Lexus NX: Installation
INSTALLATION
PROCEDURE
1. INSTALL NO. 3 BATTERY SERVICE COVER BOARD
(a) for Power Seat:
Connect the wire harness clamp and power seat switch connector.
(b) Attach the 2 claws and install the No. 3 battery service cover board.
(c) Install the 2 clips.
2. INSTALL NO. 2 BATTERY SERVICE COVER BOARD
HINT:
Use the same procedure as for the No. 3 battery service cover board.
3. INSTALL RECLINING ADJUSTER RELEASE HANDLE LH (for Manual Seat)
Click here .gif)
4. INSTALL RECLINING ADJUSTER RELEASE HANDLE RH (for Manual Seat)
Click here
5. INSTALL REAR DOOR SCUFF PLATE LH
Click here
6. INSTALL REAR DOOR SCUFF PLATE RH
Click here
7. INSTALL REAR SEAT CUSHION ASSEMBLY
for Manual seat: Click here
for Power seat: Click here
8. INSTALL CLEAR DTC
Click here
HINT:
If the message "Maintenance required for hybrid battery cooling parts at your dealer" is displayed on the multi-information display in the combination meter assembly, clean or replace the No. 2 and No. 3 battery service cover board, and clear the DTCs to reset the learning values even if no DTCs are output.
READ NEXT:
Components
COMPONENTS ILLUSTRATION *1 BATTERY VOLTAGE SENSOR *2 LOWER NO. 2 HYBRID BATTERY CARRIER PATCH N*m (kgf*cm, ft.*lbf) : Specified torque - -
Removal
REMOVAL CAUTION / NOTICE / HINT NOTICE:
The type of battery voltage sensor to be used varies depending on the vehicle model.
If the wrong type of battery voltage sensor is installed, the power sw
SEE MORE:
Camera Position Adjustment Incomplete (C1697)
DESCRIPTION This DTC is stored when the parking assist ECU judges that the camera initial setting has not been memorized (camera view adjustment is incomplete). DTC No. Detection Item DTC Detection Condition Trouble Area C1697 Camera Position Adjustment Incomplete Camera initial set
Adjustment
ADJUSTMENT CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
It is possible that a headlight assembly is incorrectly installed, affecting headlight aim. Headlight assembly installation should be considered prior to per
