Lexus NX: Installation
INSTALLATION
PROCEDURE
1. INSTALL HV BATTERY JUNCTION BLOCK ASSEMBLY
CAUTION:
Wear insulated gloves and use insulated tools.
(a) Install the hybrid battery junction block assembly with the 3 nuts.
Torque:
7.5 N·m {76 kgf·cm, 66 in·lbf}
NOTICE:
If the hybrid battery junction block assembly has been dropped, replace it with a new one.
| (b) Connect the 4 connectors. NOTICE: Make sure that the connectors are securely attached. |
|
.png)
| (c) Using an insulated tool wrapped with electrical tape, connect the 2 No. 2 frame wires (high-voltage cables) and ground terminal with the 3 nuts. Torque: 9.0 N·m {92 kgf·cm, 80 in·lbf} |
|
.png)
2. HIGH VOLTAGE CABLE CONNECTION CONDITION
Click here .gif)
3. INSTALL NO. 2 HYBRID VEHICLE BATTERY SHIELD REINFORCEMENT
Click here
4. INSTALL REAR SEAT ASSEMBLY
for Manual Seat: Click here
for Power Seat: Click here
5. INSTALL INVERTER RESERVE TANK ASSEMBLY
Click here
6. CONNECT WIRE HARNESS
Click here
7. INSTALL SERVICE PLUG GRIP
Click here
8. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL
9. INITIALIZATION AFTER RECONECTING AUXILIARY BATTERY TERMINAL
Click here
HINT:
When disconnecting and reconnecting the auxiliary battery, there is an automatic learning function that completes learning when the respective system is used.
Click here
READ NEXT:
Dtc Check / Clear
DTC CHECK / CLEAR CHECK FOR DTCS (a) Connect the Techstream to the DLC3. (b) Turn the power switch on (IG). (c) Turn the Techstream on. (d) Enter the following menus: Powertrain / Hybrid Control / Tro
Starter Relay Circuit High (P0617-142)
DESCRIPTION DTC No. Detection Item DTC Detection Condition Trouble Area MIL Warning Indicate P0617-142 Starter Relay Circuit High An ST signal from the hybrid vehicle control ECU
SEE MORE:
Data List / Active Test
DATA LIST / ACTIVE TEST DATA LIST HINT: Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be dis
Steering Angle Sensor
ComponentsCOMPONENTS ILLUSTRATION *A w/o Steering Heater *B w/ Steering Heater *1 STEERING SENSOR *2 SPIRAL CABLE SUB-ASSEMBLY RemovalREMOVAL PROCEDURE 1. REMOVE SPIRAL W/SENSOR CABLE SUB-ASSEMBLY Click here 2. REMOVE STEERING SENSOR (a) Disengage the 6 claws and 2 pi
