Lexus NX: Hybrid Control System

READ NEXT:

 Dtc Check / Clear

DTC CHECK / CLEAR CHECK FOR DTCS (a) Connect the Techstream to the DLC3. (b) Turn the power switch on (IG). (c) Turn the Techstream on. (d) Enter the following menus: Powertrain / Hybrid Control / Tro

 Starter Relay Circuit High (P0617-142)

DESCRIPTION DTC No. Detection Item DTC Detection Condition Trouble Area MIL Warning Indicate P0617-142 Starter Relay Circuit High An ST signal from the hybrid vehicle control ECU

 Internal Control Module EEPROM Error (P062F-143,P062F-165)

DESCRIPTION DTC No. Detection Item DTC Detection Condition Trouble Area MIL Warning Indicate P062F-143 Internal Control Module EEPROM Error ECU internal malfunction (EEPROM error)

SEE MORE:

 Problem Symptoms Table

PROBLEM SYMPTOMS TABLE NOTICE: Recognition code registration is necessary when replacing the main body ECU (multiplex network body ECU). If the main body ECU (multiplex network body ECU) is replaced, refer to Registration. Click here HINT: Use the table below to help determine the cau

 Drive Motor "A" Inverter Voltage Sensor Circuit Low (P0D2F-266,P0D30-267)

DESCRIPTION The inverter contains a three-phase bridge circuit, which consists of 6 power transistors (IGBTs) each for the generator (MG1), motor (MG2) and rear motor (MGR). The inverter converts high-voltage direct current from the HV battery into three-phase alternating current for the generator (

© 2016-2026 Copyright www.lexunx.com