Lexus NX: On-vehicle Inspection
ON-VEHICLE INSPECTION
CAUTION / NOTICE / HINT
CAUTION:
Be sure to follow the correct removal and installation procedures of the lower No. 1 instrument panel airbag assembly.
PROCEDURE
1. INSPECT LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY (for Vehicle not Involved in Collision)
(a) Perform a diagnostic system check.
Click here .gif)
(b) Visually check for defects with the lower No. 1 instrument panel airbag assembly installed on the vehicle.
(1) The defects are as follows:
- Cuts on the lower No. 1 instrument panel airbag assembly
- Small cracks on the lower No. 1 instrument panel airbag assembly
- Significant discoloration on the lower No. 1 instrument panel airbag assembly
OK:
No defects are found.
HINT:
If any of the defects is found, replace the lower No. 1 instrument panel airbag assembly with a new one.
2. INSPECT LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY (for Vehicle Involved in Collision and Airbag not Deployed)
(a) Perform a diagnostic system check.
Click here
(b) Visually check for defects with the lower No. 1 instrument panel airbag assembly removed from the vehicle.
(1) The defects are as follows:
- Cuts on the lower No. 1 instrument panel airbag assembly
- Small cracks on the lower No. 1 instrument panel airbag assembly
- Significant discoloration on the lower No. 1 instrument panel airbag assembly
- Cracks or other damage to the connector
- Deformation or cracks on the instrument panel or instrument panel reinforcement
OK:
No defects are found.
HINT:
If any of the defects is found, replace the lower No. 1 instrument panel airbag assembly, instrument panel or instrument panel reinforcement with a new one.
READ NEXT:
Removal
REMOVAL PROCEDURE 1. REMOVE NO. 3 DECK BOARD SUB-ASSEMBLY Click here 2. REMOVE REAR DECK FLOOR BOX Click here 3. REMOVE DECK FLOOR BOX LH Click here 4. PRECAUTION CAUTION: Be sure to read Precau
Installation
INSTALLATION CAUTION / NOTICE / HINT HINT:
Use the same procedure for RHD and LHD vehicles.
The procedures listed below are for LHD vehicles.
PROCEDURE 1. INSTALL LOWER NO. 1 INSTRUMENT PANEL
Disposal
DISPOSAL CAUTION / NOTICE / HINT CAUTION: Before performing pre-disposal deployment of any SRS part, review and closely follow all applicable environmental and hazardous material regulations. Pre-disp
SEE MORE:
Disposal
DISPOSAL CAUTION / NOTICE / HINT CAUTION: Before performing pre-disposal deployment of any SRS part, review and closely follow all applicable environmental and hazardous material regulations. Pre-disposal deployment may be considered hazardous material treatment. PROCEDURE 1. PRECAUTION CAUTION:
Diagnostic Trouble Code Chart
DIAGNOSTIC TROUBLE CODE CHART LIN Communication System DTC No. Detection Item Link B1206 P/W Master Switch Communication Stop B1273 Sliding Roof ECU Communication Stop B2321 Driver Side Door ECU Communication Stop B2322 Front Passenger Side Door ECU Comm
