Lexus NX: Installation
Lexus NX Service Manual / Vehicle Exterior / Door / Hatch / Power Back Door Touch Sensor / Installation
INSTALLATION
CAUTION / NOTICE / HINT
HINT:
- Use the same procedure for the RH and LH sides.
- The procedure listed below is for the LH side.
PROCEDURE
1. INSTALL POWER BACK DOOR SENSOR ASSEMBLY LH
(a) Attach the 2 clips to install the power back door sensor assembly LH.
(b) Install the 4 screws.
(c) Connect the connector.
2. INSTALL BACK DOOR TRIM BOARD ASSEMBLY
Click here .gif)
3. INSTALL BACK DOOR LOCK COVER
Click here
4. INSTALL BACK DOOR TRIM BASE
Click here
5. INSTALL PULL HANDLE
Click here
6. INSTALL BACK DOOR SIDE GARNISH LH
Click here
7. INSTALL BACK DOOR SIDE GARNISH RH
Click here
8. INSTALL BACK DOOR CENTER GARNISH
Click here
READ NEXT:
Components
COMPONENTS ILLUSTRATION *A w/ Woofer *B w/o Woofer *1 BACK DOOR CENTER GARNISH *2 BACK DOOR LOCK COVER *3 BACK DOOR SIDE GARNISH LH *4 BACK DOOR SIDE GARNISH RH *5
Removal
REMOVAL PROCEDURE 1. REMOVE BACK DOOR CENTER GARNISH Click here 2. REMOVE BACK DOOR SIDE GARNISH LH Click here 3. REMOVE BACK DOOR SIDE GARNISH RH Click here 4. REMOVE BACK DOOR TRIM BASE Cli
SEE MORE:
Back Camera Power Supply Failure (C1621)
DESCRIPTION This DTC is stored if the parking assist ECU determines that the input/output signal communication with the rear television camera assembly is abnormal. DTC No. Detection Item DTC Detection Condition Trouble Area C1621 Back Camera Power Supply Failure Rear television cam
Precaution
PRECAUTION PRECAUTIONS WHEN USING TECHSTREAM (a) When using the Techstream with the vehicle power switch off, connect the Techstream to the DLC3 and turn a courtesy light switch on and off at intervals of 1.5 seconds or less until communication between the Techstream and the vehicle begins. Then sel
© 2016-2026 Copyright www.lexunx.com
