Lexus NX: Power Back Door Touch Sensor
READ NEXT:
Components
COMPONENTS ILLUSTRATION *1 BACK DOOR CENTER GARNISH *2 BACK DOOR LOCK COVER *3 BACK DOOR SIDE GARNISH LH *4 BACK DOOR SIDE GARNISH RH *5 BACK DOOR TRIM BASE *6 BACK DOOR
Removal
REMOVAL CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
PROCEDURE 1. REMOVE BACK DOOR CENTER GARNISH Click here
Inspection
INSPECTION PROCEDURE 1. INSPECT POWER BACK DOOR SENSOR ASSEMBLY LH (a) Measure the resistance according to the value(s) in the table below. Standard Resistance: Tester Connection Condition
SEE MORE:
Additional Key cannot be Registered
DESCRIPTION If additional registration is not possible, a malfunction in the electrical key transmitter sub-assembly, certification ECU (smart key ECU assembly), power switch, No. 2 indoor electrical key antenna assembly (front floor), steering lock ECU (steering lock actuator assembly) or door cont
Back Door Closer Switch Malfunction (B2251)
DESCRIPTION The multiplex network door ECU receives signals from the latch switch, initial switch, pawl switch and back door courtesy switch, which are built into the back door lock assembly. Based on these switch signals, the latch position of the back door lock assembly is determined. DTC No.
© 2016-2026 Copyright www.lexunx.com
