Lexus NX: Installation
INSTALLATION
CAUTION / NOTICE / HINT
HINT:
- Use the same procedure for the RH and LH sides.
- The procedure listed below is for the LH side.
PROCEDURE
1. INSTALL OUTER REAR VIEW MIRROR ASSEMBLY LH
(a) Attach the claw to temporarily install the outer rear view mirror assembly LH.
(b) Install the outer rear view mirror assembly LH with the 3 nuts.
Torque:
5.5 N·m {56 kgf·cm, 49 in·lbf}
(c) w/o Memory, w/ Memory:
(1) Connect the connector.
(d) w/ Panoramic View Monitor System:
(1) Connect the 2 connectors.
2. INSTALL OUTER MIRROR INSTALL HOLE COVER LH
(a) Attach the 4 claws and install the outer mirror install hole cover LH.
(b) Attach the clamp.
3. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH
Click here .gif)
4. INSTALL POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Front Passenger Side)
Click here
5. INSTALL POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Driver Side)
Click here
6. INSTALL FRONT DOOR INSIDE HANDLE BEZEL PLUG LH
Click here
7. INSTALL FRONT DOOR TRIM COVER LH
Click here
READ NEXT:
Components
COMPONENTS ILLUSTRATION *1 OUTER MIRROR LH - -
Removal
REMOVAL CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
PROCEDURE 1. REMOVE OUTER MIRROR LH (a) Push the upper part
SEE MORE:
Inside rear view mirror
The rear view mirror's position can
be adjusted to enable sufficient
confirmation of the rear view.
Adjusting the height of rear view
mirror
The height of the rear view mirror can
be adjusted to suit your driving posture.
Adjust the height of the rear view mirror
by moving it up and down.
Back Camera Power Supply Failure (C1621)
DESCRIPTION This DTC is stored if the rear television camera assembly judges as a result of its self check that the signals or signal lines between the rear television camera assembly and multi-display assembly are not normal. DTC No. Detection Item DTC Detection Condition Trouble Area
