Lexus NX: Installation
INSTALLATION
CAUTION / NOTICE / HINT
HINT:
A bolt without a torque specification is shown in the standard bolt chart.
Click here .gif)
PROCEDURE
1. INSTALL ELECTRICAL KEY AND TPMS RECEIVER ASSEMBLY
(a) Connect the connector.
(b) Attach the 2 guides and Install the electrical key and TPMS receiver assembly.
(c) Install the bolt.
Torque:
8.3 N·m {85 kgf·cm, 73 in·lbf}
2. INSTALL INNER ROOF SIDE GARNISH ASSEMBLY RH
Click here
3. INSTALL DECK TRIM SIDE PANEL ASSEMBLY RH
Click here
4. INSTALL UPPER DECK TRIM SIDE BOARD RH
Click here
5. INSTALL NO. 1 LUGGAGE COMPARTMENT TRIM HOOK
Click here
6. INSTALL LUGGAGE HOLD BELT STRIKER ASSEMBLY
Click here
7. INSTALL ROPE HOOK ASSEMBLY
Click here
8. INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP RH
Click here
9. INSTALL NO. 1 SEAT LEG ASSEMBLY
-
for Manual Seat:
Click here
-
for Power Seat:
Click here
10. INSTALL BATTERY SERVICE COVER BOARD
-
for Manual Seat:
Click here
-
for Power Seat:
Click here
11. INSTALL REAR FLOOR FINISH PLATE
Click here
12. INSTALL NO. 2 TOOL BOX SUB-ASSEMBLY
Click here
13. INSTALL NO. 1 TOOL BOX SUB-ASSEMBLY
Click here
14. INSTALL DECK FLOOR BOX RH
Click here
15. INSTALL NO. 2 DECK BOARD SUB-ASSEMBLY
Click here
16. INSTALL TONNEAU COVER ASSEMBLY
Click here
17. INSTALL REAR SEAT ASSEMBLY
-
for Manual Seat:
Click here
-
for Power Seat:
Click here
18. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL
19. INITIALIZATION AFTER RECONNECTING AUXILIARY BATTERY TERMINAL
Click here
HINT:
When disconnecting and reconnecting the auxiliary battery, there is an automatic learning function that completes learning when the respective system is used.
Click here
20. INSTALL DECK FLOOR BOX LH
Click here
21. INSTALL REAR DECK FLOOR BOX
Click here
22. INSTALL NO. 3 DECK BOARD SUB-ASSEMBLY
Click here
23. INSTALL DECK BOARD ASSEMBLY
Click here
24. REGISTRATION OF TRANSMITTER ID
Click here
25. INSPECT TIRE PRESSURE WARNING SYSTEM
Click here
26. PERFORM INITIALIZATION
Click here
READ NEXT:
Door Control Switch
ComponentsCOMPONENTS ILLUSTRATION *1 DOOR CONTROL SWITCH ASSEMBLY *2 POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL *3 FRONT DOOR ARMREST BASE PANEL - -
Components
COMPONENTS ILLUSTRATION *1 TRANSMITTER BATTERY *2 DOOR CONTROL TRANSMITTER HOUSING SET *3 TRANSMITTER BATTERY HOLDER *4 MECHANICAL KEY *5 ELECTRICAL TRANSMITTER SUB-ASSEMBLY
SEE MORE:
For your information
Main Owner's Manual
Please note that this manual applies to
all models and explains all equipment,
including options. Therefore, you may
find some explanations for equipment
not installed on your vehicle.
All specifications provided in this manual
are current at the time of printing.
How
Reassembly
REASSEMBLY PROCEDURE 1. INSTALL NO. 2 MOULDING TAPE HINT:
When installing the No. 2 moulding tape, heat the front bumper cover and No. 2 moulding tape using a heat light.
Use the same procedure described for the other side.
Standard: Item Temperature Front Bumper Cover 20 to 30°
