Lexus NX: Operation Check
OPERATION CHECK
AUTOMATIC LIGHT CONTROL SYSTEM OPERATION CHECK
(a) Turn the power switch on (IG).
(b) Turn the headlight dimmer switch to the AUTO position.
(c) Cover the automatic light control sensor.
(d) Check that the taillights and low beam headlights come on.
(e) Uncover the automatic light control sensor.
(f) Check that the low beam headlights and taillights turn off.
DAYTIME RUNNING LIGHT SYSTEM
(a) Headlight dimmer switch is in the tail or AUTO position (and the low beam headlights are not turned on via the automatic light control system).
(b) READY condition is received.
(c) Release the parking brake.
(d) Check that the daytime running lights come on.
WELCOME LIGHT ILLUMINATION CONTROL OPERATION CHECK
NOTICE:
This check is possible only when the "Light up Clearance Lights at Door Unlock Function" customize setting is set to "ON" on the Techstream. (The default setting is "ON".)
Click here .gif)
(a) Turn the power switch on (IG).
(b) Turn the headlight dimmer switch (light control switch) to the AUTO position.
(c) Cover the automatic light control sensor.
(d) Turn the power switch off.
(e) Close and lock all doors.
(f) Unlock all doors by wireless door unlock or entry door unlock.
(g) Check that the taillights, clearance lights and license plate lights turn on for approximately 15 seconds.
READ NEXT:
Customize Parameters
CUSTOMIZE PARAMETERS CUSTOMIZE LIGHTING SYSTEM (EXT) NOTICE:
When the customer requests a change in a function, first make sure that the function can be customized.
Record the current settings be
Problem Symptoms Table
PROBLEM SYMPTOMS TABLE NOTICE:
Recognition code registration is necessary when replacing the main body ECU (multiplex network body ECU).
If the main body ECU (multiplex network body ECU) is repla
Terminals Of Ecu
TERMINALS OF ECU CHECK INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY, MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) (a) Remove the main body ECU (multiplex network body ECU) from the instrument panel junction
SEE MORE:
Mass Air Flow Meter
ComponentsCOMPONENTS ILLUSTRATION *1 MASS AIR FLOW METER SUB-ASSEMBLY - - On-vehicle InspectionON-VEHICLE INSPECTION CAUTION / NOTICE / HINT NOTICE:
Perform the mass air flow meter sub-assembly inspection according to the procedures below.
Only replace the mass air flow meter sub
Adjustment
ADJUSTMENT PROCEDURE 1. INSPECT AND ADJUST BRAKE PEDAL HEIGHT (a) Check the brake pedal height. *1 Brake Pedal Pad - - *a Brake Pedal Height *b Measuring Plane of Floor Panel Brake pedal height from floor panel: 188.9 to 198.9 mm (7.44 to 7.83 in.) (b) Adjust the brake pedal
