Lexus NX: Precaution

PRECAUTION

PRECAUTION FOR VEHICLE WITH AIRBAG

(a) Some operations in this section may affect the airbag. Prior to performing the corresponding operations, read the SRS Precaution.

Click here

READ NEXT:

 Components

COMPONENTS ILLUSTRATION *1 DECK FLOOR BOX LH *2 NO. 3 DECK BOARD SUB-ASSEMBLY *3 REAR DECK FLOOR BOX *4 NEGATIVE AUXILIARY BATTERY TERMINAL N*m (kgf*cm, ft.*lbf): Specified

 Removal

REMOVAL PROCEDURE 1. TABLE OF BOLT, SCREW AND CLIP HINT: All bolts, screws, and clips relevant to installing and removing the instrument panel are shown along with their alphabet code in the table bel

 Disassembly

DISASSEMBLY PROCEDURE 1. REMOVE GLOVE COMPARTMENT DOOR CHECK CUSHION HINT: Use the same procedure for both glove compartment door check cushions. (a) Using a screwdriver, detach the 3 claws and rem

SEE MORE:

 Generator Control Module (P0A1A-658,P0A1A-791,P1C2A-155,P1CA6-156,P3133-659)

DESCRIPTION The MG ECU, which is built into the inverter with converter assembly, monitors its internal operation and will store DTCs if the system is malfunctioning. If any of the following DTCs are output, replace the inverter with converter assembly. DTC No. Detection Item DTC Detection Co

 Installation

INSTALLATION PROCEDURE 1. INSTALL ENGINE WATER PUMP ASSEMBLY (a) Install a new gasket and the engine water pump assembly with the 5 bolts in the order shown in the illustration. Torque: 10 N·m {102 kgf·cm, 7 ft·lbf} 2. INSTALL V-RIBBED BELT TENSIONER ASSEMBLY (a) Using a 12 mm

© 2016-2026 Copyright www.lexunx.com