Lexus NX: Installation
INSTALLATION
PROCEDURE
1. INSTALL METER MIRROR SUB-ASSEMBLY (HEADUP DISPLAY)
| (a) Install the meter mirror sub-assembly (headup display) with the 4 screws. |
|
(b) Connect the connector.
2. INSTALL NO. 1 HEATER TO REGISTER DUCT SUB-ASSEMBLY
(a) Install the No. 1 heater to register duct sub-assembly with the 3 screws.
3. INSTALL UPPER INSTRUMENT PANEL SUB-ASSEMBLY
Click here .gif)
4. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL
5. INITIALIZATION AFTER RECONNECTING AUXILIARY BATTERY TERMINAL
Click here
HINT:
When disconnecting and reconnecting the auxiliary battery, there is an automatic learning function that completes learning when the respective system is used.
Click here
6. ENABLE AUTOAWAY/RETURN FUNCTION
(a) Restore the autoaway/return function setting to the previous condition by changing the customize parameter.
Click here
7. CHECK SRS WARNING LIGHT
Click here
8. INSTALL DECK FLOOR BOX LH
Click here
9. INSTALL REAR DECK FLOOR BOX
Click here
10. INSTALL NO. 3 DECK BOARD SUB-ASSEMBLY
Click here
READ NEXT:
Components
COMPONENTS ILLUSTRATION *1 CONSOLE ARMREST ASSEMBLY *2 HEADUP DISPLAY SWITCH ASSEMBLY *3 INSTRUMENT SIDE PANEL LH *4 LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL *5 NO. 1 INSTRU
Removal
REMOVAL PROCEDURE 1. REMOVE CONSOLE ARMREST ASSEMBLY Click here 2. REMOVE UPPER NO. 2 CONSOLE PANEL GARNISH Click here 3. REMOVE INSTRUMENT SIDE PANEL LH Click here 4. REMOVE NO. 1 INSTRUM
SEE MORE:
Adjustment
ADJUSTMENT CAUTION / NOTICE / HINT NOTICE: If a wheel alignment has been performed, or if suspension or underbody components have been removed/installed or replaced, be sure to perform the following initialization procedure in order for the system to function normally:
Perform zero point calibrat
Reverse Signal Circuit between Radio Receiver Assembly and Navigation ECU
DESCRIPTION This circuit includes the navigation ECU and radio and display receiver assembly. WIRING DIAGRAM PROCEDURE 1. CHECK HARNESS AND CONNECTOR (RADIO RECEIVER ASSEMBLY - NAVIGATION ECU) (a) Disconnect the I153 radio receiver assembly connector. (b) Disconnect the I173 navigation ECU
