Lexus NX: Headup Display

READ NEXT:

 Components

COMPONENTS ILLUSTRATION *1 DECK FLOOR BOX LH *2 NO. 3 DECK BOARD SUB-ASSEMBLY *3 REAR DECK FLOOR BOX *4 NEGATIVE AUXILIARY BATTERY TERMINAL N*m (kgf*cm, ft.*lbf): Specified

 Removal

REMOVAL PROCEDURE 1. DISABLE AUTOAWAY/RETURN FUNCTION (for Power Tilt and Power Telescopic Steering Column) (a) Disable the autoaway/return function by changing the customize parameter. Click here C

 Disassembly

DISASSEMBLY PROCEDURE 1. REMOVE NO. 1 COMBINATION METER MIRROR PLATE (a) Detach the 10 claws and remove the No. 1 combination meter mirror plate from the meter mirror sub-assembly (headup display).

SEE MORE:

 Installation

INSTALLATION PROCEDURE 1. INSTALL ULTRASONIC SENSOR CUSHION SET HINT: Perform the following procedure only when replacement of a ultrasonic sensor cushion set is necessary. (a) Install the ultrasonic sensor cushion set as shown in the illustration. Install in this Direction - - 2. INST

 Inspection

INSPECTION PROCEDURE 1. INSPECT SEPARATE TYPE REAR SEATBACK COVER RH (REAR SEATBACK HEATER ASSEMBLY RH) (for RH Side) (a) Check the separate type rear seatback cover RH (rear seatback heater assembly RH). (1) Measure the resistance according to the value(s) in the table below. Standard Resistance

© 2016-2026 Copyright www.lexunx.com