Lexus NX: Installation
INSTALLATION
PROCEDURE
1. INSTALL OCCUPANT DETECTION ECU
(a) Attach the claw to install the occupant detection ECU.
NOTICE:
If the occupant detection ECU has been dropped, or there are any cracks, dents or other defects in the case or connector, replace the occupant detection ECU with a new one.
(b) Connect the 2 connectors.
NOTICE:
When installing the occupant detection ECU, be careful that the SRS wiring does not interfere with or is pinched between other parts.
2. INSTALL FRONT SEAT ASSEMBLY RH
Click here .gif)
3. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL
(a) Connect the cable to the negative (-) auxiliary battery terminal and tighten the nut.
Torque:
5.4 N·m {55 kgf·cm, 48 in·lbf}
4. INITIALIZATION AFTER RECONNECTING AUXILIARY BATTERY TERMINAL
Click here
HINT:
When disconnecting and reconnecting the auxiliary battery, there is an automatic learning function that completes learning when the respective system is used.
Click here
5. ZERO POINT CALIBRATION AND SENSITIVITY CHECK
Click here
6. PERFORM DIAGNOSTIC SYSTEM CHECK
Click here
7. CHECK SRS WARNING LIGHT
Click here
8. INSTALL DECK FLOOR BOX LH
Click here
9. INSTALL REAR DECK FLOOR BOX
Click here
10. INSTALL NO. 3 DECK BOARD SUB-ASSEMBLY
Click here
READ NEXT:
Precaution
PRECAUTION PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL NOTICE:
After turning the power switch off, waiting time may be required before disconnecting the cable from t
Parts Location
PARTS LOCATION ILLUSTRATION *1 NO. 2 ENGINE ROOM RELAY BLOCK - ODS FUSE *2 FRONT SEAT INNER BELT ASSEMBLY RH *3 AIR CONDITIONING CONTROL ASSEMBLY *4 OCCUPANT DETECTION ECU *5
SEE MORE:
Poor Sound Quality in All Modes (Low Volume)
PROCEDURE 1. CHECK AUDIO SETTINGS (a) Set treble, middle and bass to the initial values and check that the sound is normal. OK: The sound returns to normal. HINT: Sound quality adjustment measures vary according to the type of amplifier. OK END
NG 2. COMPARE
On-vehicle Inspection
ON-VEHICLE INSPECTION CAUTION / NOTICE / HINT CAUTION: Be sure to follow the correct removal and installation procedures of the occupant classification ECU. PROCEDURE 1. INSPECT OCCUPANT DETECTION ECU (for Vehicle not Involved in Collision) (a) Perform a diagnostic system check. Click here 2. INS
