Lexus NX: Installation
INSTALLATION
PROCEDURE
1. INSTALL BLIND SPOT MONITOR BUZZER
(a) Attach the clamp to install the blind spot monitor buzzer.
(b) Connect the connector.
2. INSTALL DECK TRIM SIDE PANEL ASSEMBLY RH
Click here .gif)
3. INSTALL NO. 1 LUGGAGE COMPARTMENT TRIM HOOK
Click here
4. INSTALL LUGGAGE HOLD BELT STRIKER ASSEMBLY
Click here
5. INSTALL ROPE HOOK ASSEMBLY
Click here
6. INSTALL UPPER DECK TRIM SIDE BOARD RH
Click here
7. CONNECT REAR DOOR OPENING TRIM WEATHERSTRIP RH
Click here
8. INSTALL REAR FLOOR FINISH PLATE
Click here
9. INSTALL REAR SEAT ASSEMBLY
(a) for Manual Seat:
Click here
(b) for Power Seat:
Click here
READ NEXT:
Television Camera (for Front)
ComponentsCOMPONENTS ILLUSTRATION *1 FRONT TELEVISION CAMERA ASSEMBLY - - RemovalREMOVAL PROCEDURE 1. PRECAUTION Click here 2. REMOVE FRONT BUMPER COVER (a) for Sport Package: Click h
Components
COMPONENTS ILLUSTRATION *A w/ Woofer *B w/o Woofer *C w/o Power Back Door *D w/ Power Back Door *1 BACK DOOR CENTER GARNISH *2 BACK DOOR FINISH COVER LH *3 BACK DOO
SEE MORE:
Operation Check
OPERATION CHECK INSPECT ASC SYSTEM OPERATION CAUTION: Check for safety before performing any tests. HINT: When the drive mode changes to a mode other than NORMAL, SPORT or CUSTOMIZE*, the simulated engine sound stops. *: Customize mode refers to when the following conditions are set on the multi-dis
Visual Mute Signal Circuit between Radio Receiver and Multi-display
DESCRIPTION The radio receiver assembly sends a visual mute signal to the multi-display assembly. As a result, a black screen is inserted when the screen changes so that noise and distorted images are not displayed. When an open exists in the circuit, noise and distorted images will be displayed ins
© 2016-2026 Copyright www.lexunx.com
