Lexus NX: Components
Lexus NX Service Manual / Vehicle Exterior / Exterior Panels / Trim / Front Door Outside Moulding / Components
COMPONENTS
ILLUSTRATION
| *1 | FRONT DOOR LOWER OUTSIDE MOULDING SUB-ASSEMBLY LH | *2 | HOLE COVER |
ILLUSTRATION
| *1 | FRONT DOOR UPPER OUTSIDE MOULDING PAD | - | - |
| ● | Non-reusable part | - | - |
READ NEXT:
Removal
REMOVAL CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH and LH sides.
The procedures listed below are for the LH side.
PROCEDURE 1. REMOVE FRONT DOOR LOWER OUTSIDE MOULDING SUB
Disassembly
DISASSEMBLY CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
PROCEDURE 1. REMOVE FRONT DOOR UPPER OUTSIDE MOULDING P
Reassembly
REASSEMBLY CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
PROCEDURE 1. INSTALL FRONT DOOR UPPER OUTSIDE MOULDING P
SEE MORE:
Calibration
CALIBRATION TORQUE SENSOR ZERO POINT CALIBRATION (USING THE Techstream) NOTICE: Perform torque sensor zero point calibration if any of the following conditions occur:
The power steering ECU assembly has been replaced.
The electric power steering column sub-assembly has been replaced.
There is
Operation Check
OPERATION CHECK CHECK WINDSHIELD DEICER SYSTEM (a) Turn the power switch on (IG). (b) Check that the windshield deicer becomes warm by operating the windshield deicer switch of the multi-display assembly. (c) When the vehicle is stopped, confirm that the windshield deicer stops after approximately 1
© 2016-2025 Copyright www.lexunx.com
