Lexus NX: Rear Cross Traffic Alert Buzzer

READ NEXT:

 Components

COMPONENTS ILLUSTRATION *1 BLIND SPOT MONITOR BUZZER *2 DECK TRIM SIDE PANEL ASSEMBLY RH *3 LUGGAGE HOLD BELT STRIKER ASSEMBLY *4 NO. 1 LUGGAGE COMPARTMENT TRIM HOOK *5 REAR

 Removal

REMOVAL PROCEDURE 1. REMOVE REAR SEAT ASSEMBLY (a) for Manual Seat: Click here (b) for Power Seat: Click here 2. REMOVE REAR FLOOR FINISH PLATE Click here 3. DISCONNECT REAR DOOR OPENING TRIM W

 Installation

INSTALLATION PROCEDURE 1. INSTALL BLIND SPOT MONITOR BUZZER (a) Attach the clamp to install the blind spot monitor buzzer. (b) Connect the connector. 2. INSTALL DECK TRIM SIDE PANEL ASSEMBLY RH Click

SEE MORE:

 Customize Parameters

CUSTOMIZE PARAMETERS CUSTOMIZE METER / GAUGE SYSTEM (a) Customizing with the Techstream (1) Connect the Techstream to the DLC3. (2) Turn the power switch on (IG). (3) Turn the Techstream on. (4) Enter the following menus: Customize Setting / Warning or Display. (5) Select the setting by referring to

 Inspection

INSPECTION PROCEDURE 1. INSPECT FOG LIGHT ASSEMBLY LH (a) Apply battery voltage to the connector and check the light illumination condition. OK: Condition Specified Condition Battery positive (+) → 2 (B) Battery negative (-) → 1 (E) Illuminates If the result is not as specified

© 2016-2025 Copyright www.lexunx.com