Lexus NX: Installation
INSTALLATION
PROCEDURE
1. INSTALL FUEL PUMP CONTROL ECU ASSEMBLY
Click here .gif)
2. INSTALL PARKING BRAKE ECU ASSEMBLY
(a) Install the parking brake ECU assembly with the 2 bolts.
Torque:
8.0 N·m {82 kgf·cm, 71 in·lbf}
(b) Connect the 3 connectors.
3. INSTALL DECK TRIM SIDE PANEL ASSEMBLY LH
Click here
4. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL
(a) Connect the negative (-) auxiliary battery terminal and tighten the nut.
Torque:
5.4 N·m {55 kgf·cm, 48 in·lbf}
5. INITIALIZATION AFTER RECONECTING AUXILIARY BATTERY TERMINAL
Click here
HINT:
When disconnecting and reconnecting the auxiliary battery, there is an automatic learning function that completes learning when the respective system is used.
Click here
6. INSTALL DECK FLOOR BOX LH
Click here
7. INSTALL REAR DECK FLOOR BOX
Click here
8. INSTALL NO. 3 DECK BOARD SUB-ASSEMBLY
Click here
READ NEXT:
Components
COMPONENTS ILLUSTRATION *1 CENTER INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY *2 INSTRUMENT SIDE PANEL LH *3 INSTRUMENT SIDE PANEL RH *4 LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL
Removal
REMOVAL PROCEDURE 1. REMOVE CONSOLE ARMREST ASSEMBLY Click here 2. REMOVE UPPER REAR CONSOLE PANEL Click here 3. REMOVE UPPER NO. 2 CONSOLE PANEL GARNISH Click here 4. REMOVE UPPER NO. 1 CON
SEE MORE:
Panel Switches do not Function
CAUTION / NOTICE / HINT NOTICE: When replacing the radio receiver assembly, always replace it with a new one. If a radio receiver assembly which was installed to another vehicle is used, the following may occur:
A communication malfunction DTC may be stored.
The radio receiver assembly may not
Part of HV Gate Blocking Range/Performance (P321F-319)
DESCRIPTION Refer to the description for DTC P321E-318. Click here DTC No. Detection Item DTC Detection Condition Trouble Area MIL Warning Indicate P321F-319 Part of HV Gate Blocking Range/Performance An open or ground short in the HV gate block signal circuit when the gate is
