Lexus NX: Kick Sensor
READ NEXT:
Components
COMPONENTS ILLUSTRATION *1 KICK DOOR CONTROL BRACKET *2 KICK DOOR CONTROL SENSOR
Removal
REMOVAL PROCEDURE 1. REMOVE REAR BUMPER COVER Click here 2. REMOVE KICK DOOR CONTROL BRACKET (a) Disconnect the connector and detach the 2 wire harness clamps. NOTICE: Do not touch the terminal o
Installation
INSTALLATION PROCEDURE 1. INSTALL KICK DOOR CONTROL SENSOR (a) Insert the guide, attach the 2 claws and install the kick door control sensor to the kick door control bracket as shown in the illustr
SEE MORE:
How To Proceed With Troubleshooting
PROCEDURE 1. CHECK TIRE AND WHEEL SYSTEM DIAGNOSIS OF IRREGULAR TIRE WEAR GO TO STEP 11
DIAGNOSIS OF TIRE VIBRATION 2. TIGHTEN WHEEL NUTS
NEXT 3. INSPECT TIRES Click here NG GO TO STEP 10
OK 4.
Open Circuit in Main Relay 1 (C1311,C1312)
DESCRIPTION The ABS main relay supplies power to the changeover solenoid and the linear solenoid. The ABS main relay remains on for approximately 2 minutes after the power switch is turned off and the input of brake pedal operation signals stops, and supplies power to the system to keep it ready to
© 2016-2026 Copyright www.lexunx.com
