Lexus NX: Left Headlight ECU Variation Error (B2456)
DESCRIPTION
This DTC is output when a headlight ECU sub-assembly LH that is incompatible with the vehicle is installed.
The headlight ECU sub-assembly LH outputs DTC B2456.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| B2456 | Left Headlight ECU Variation Error | Headlight ECU sub-assembly LH variation mismatch |
|
PROCEDURE
| 1. | CHECK FOR DTC |
(a) Clear the DTCs.
Click here .gif)
(b) Turn the power switch on (IG).
(c) Check for DTCs.
Click here
OK:
DTC B2456 output does not occur.
| OK | .gif) | USE SIMULATION METHOD TO CHECK |
|
.gif)
| 2. | CHECK HYBRID VEHICLE CONTROL ECU |
(a) Check that the hybrid vehicle control ECU part number matches the vehicle.
| Result | Proceed to |
|---|---|
| Hybrid vehicle control ECU part number matches vehicle | A |
| Hybrid vehicle control ECU part number does not match | B |
| A | | REPLACE HEADLIGHT ECU SUB-ASSEMBLY LH |
| B | | REPLACE HYBRID VEHICLE CONTROL ECU |
READ NEXT:
Control Module Communication Bus "A" Off (U0073,U0100,U0101,U0126,U0129,U0142,U0155,U0293)
DESCRIPTION DTC No. Detection Item DTC Detection Condition Trouble Area U0073 Control Module Communication Bus "A" Off Bus off condition is detected. CAN communication system U0
Lost Communication with Multi-axis Acceleration Sensor Module Missing Message (U012587,U012987,U014087,U029387)
DESCRIPTION DTC No. Detection Item DTC Detection Condition Trouble Area DTC Output from U012587 Lost Communication with Multi-axis Acceleration Sensor Module Missing Message Communi
Lost Communication with Cruise Control Front Distance Range Sensor Missing Message (U023587,U0242)
DESCRIPTION DTC No. Detection Item DTC Detection Condition Trouble Area DTC Output from Note U023587 Lost Communication with Cruise Control Front Distance Range Sensor Missing Messa
SEE MORE:
Removal
REMOVAL CAUTION / NOTICE / HINT CAUTION: Wear protective gloves. Sharp areas on the parts may injure your hands. PROCEDURE 1. REMOVE REAR SEAT ASSEMBLY Click here 2. REMOVE REAR SEATBACK COVER Click here 3. REMOVE REAR SEAT INNER WITH CENTER BELT ASSEMBLY RH (for RH Side) Click here 4. REMOVE
Luggage Compartment Room Light
ComponentsCOMPONENTS ILLUSTRATION *1 NO. 1 LUGGAGE COMPARTMENT LIGHT ASSEMBLY - - RemovalREMOVAL PROCEDURE 1. REMOVE NO. 1 LUGGAGE COMPARTMENT LIGHT ASSEMBLY (for LH Side) (a) Put protective tape around the No. 1 luggage compartment light assembly. Protective Tape (b) Using
