Lexus NX: Light Control Rheostat

READ NEXT:

 Components

COMPONENTS ILLUSTRATION *1 INSTRUMENT SIDE PANEL LH *2 NO. 1 INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY *3 TRIP SWITCH (LIGHT CONTROL RHEOSTAT) - -

 Removal

REMOVAL PROCEDURE 1. REMOVE INSTRUMENT SIDE PANEL LH Click here 2. REMOVE NO. 1 INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY Click here 3. REMOVE TRIP SWITCH (LIGHT CONTROL RHEOSTAT) (a) Using

 Inspection

INSPECTION PROCEDURE 1. INSPECT TRIP SWITCH (LIGHT CONTROL RHEOSTAT) *1 Up Switch *2 Down Switch *a Component without harness connected (Trip Switch (Light Control Rheostat)) (a)

SEE MORE:

 Blind Spot Monitor Slave Module Beam Axis Inspection Incomplete (C1ABC)

DESCRIPTION This DTC is stored when a beam axis inspection has not been performed for the blind spot monitor sensor RH. HINT: This DTC is always stored after replacing a blind spot monitor sensor. The purpose of this DTC is to ensure that beam axis inspection is performed. Completing the beam axis i

 Lost Communication with Main Body ECU (U0140,U0142,U0155,U0293,U1117)

DESCRIPTION These DTCs are stored when there is a CAN communication error between the hybrid vehicle control ECU, certification ECU (smart key ECU assembly), ECM, main body ECU (multiplex network body ECU) or combination meter assembly, and data from the option connector (bus buffer ECU) cannot be r

© 2016-2026 Copyright www.lexunx.com