Lexus NX: Lost Communication with Cruise Control Front Distance Range Sensor Single Sensor or Center Missing Message (U023587)

Lexus NX Service Manual / Engine & Hybrid System / Cruise Control / Lane Tracing Assist System / Lost Communication with Cruise Control Front Distance Range Sensor Single Sensor or Center Missing Message (U023587)

DESCRIPTION

The forward recognition camera is connected to the millimeter wave radar sensor assembly via the CAN communication line. When the signal from the millimeter wave radar sensor assembly is interrupted, the forward recognition camera outputs U023587.

DTC No.

Detection Item

DTC Detection Condition

Trouble Area

U023587

Lost Communication with Cruise Control Front Distance Range Sensor Single Sensor or Center Missing Message

3 seconds after the power switch is turned on (IG), while the lane tracing assist is on, a communication data malfunction occurs between the forward recognition camera and millimeter wave radar sensor assembly continues for 5 seconds or more

Pre-collision system

PROCEDURE

1.

GO TO PRE-COLLISION SYSTEM

HINT:

If DTC U023587 is output by the lane tracing assist system, perform troubleshooting for the pre-collision system DTC U023587.

Click here

Next

END

READ NEXT:

 Internal Control Module Software Incompatibility Not Programmed (U030051,U030057)

DESCRIPTION When the forward recognition camera is unable to determine the vehicle information from the vehicle information sent from the hybrid vehicle control ECU, the forward recognition camera

 Steering Pad Switch Circuit

DESCRIPTION The forward recognition camera receives the LTA/LDA main switch on/off signal from the steering pad switch assembly. WIRING DIAGRAM CAUTION / NOTICE / HINT NOTICE: During the steering pad

 Indicator Circuit

DESCRIPTION The LTA/LDA indicator output request signal is sent from the forward recognition camera to the combination meter assembly via CAN communication. CAUTION / NOTICE / HINT NOTICE: When rep

SEE MORE:

 Removal

REMOVAL PROCEDURE 1. RELEASE PARKING BRAKE (a) With the power switch on (IG), operate the electric parking brake switch to release the parking brake. Then turn the power switch off. HINT: If the parking brake cannot be released, Click here 2. REMOVE REAR WHEEL Click here 3. REMOVE PARKING BRAKE

 Short in Side Squib (LH) Circuit (B1825-B1828)

DESCRIPTION The front side squib LH circuit consists of the airbag ECU assembly and front seat airbag assembly LH. The circuit instructs the SRS to deploy when deployment conditions are met. These DTCs are stored when a malfunction is detected in the front side squib LH circuit. DTC No. Detecti

© 2016-2024 Copyright www.lexunx.com