Lexus NX: On-vehicle Inspection
ON-VEHICLE INSPECTION
CAUTION / NOTICE / HINT
CAUTION:
Be sure to correctly follow the removal and installation procedures for the front seat outer belt assembly.
PROCEDURE
1. INSPECT FRONT SEAT OUTER BELT ASSEMBLY (for Vehicle not Involved in Collision)
(a) Perform a diagnostic system check.
Click here .gif)
(b) Visually check for defects with the front seat outer belt assembly installed to the vehicle.
(1) The defects to be checked are as follows:
- Cuts on the front seat outer belt assembly
- Small cracks on the front seat outer belt assembly
- Significant discoloration on the front seat outer belt assembly
OK:
No defects are found.
HINT:
If any defects are found, replace the front seat outer belt assembly with a new one.
2. INSPECT FRONT SEAT OUTER BELT ASSEMBLY (for Vehicle Involved in Collision)
(a) Perform a diagnostic system check.
Click here
(b) Visually check for defects with the front seat outer belt assembly removed from the vehicle.
(1) The defects to be checked are as follows:
- Cuts on the front seat outer belt assembly
- Small cracks on the front seat outer belt assembly
- Significant discoloration on the front seat outer belt assembly
- Cracks or other damage on the connector
OK:
No defects are found.
HINT:
If any defects are found, replace the front seat outer belt assembly with a new one.
READ NEXT:
Inspection
INSPECTION PROCEDURE 1. INSPECT FRONT SEAT OUTER BELT ASSEMBLY (a) Before installing the front seat outer belt assembly, check the ELR function. NOTICE: Do not disassemble the retractor. (1) When t
Rear Center Seat Outer Belt Assembly
ComponentsCOMPONENTS ILLUSTRATION *1 REAR CENTER SEAT OUTER BELT ASSEMBLY *2 SEAT BELT ANCHOR COVER N*m (kgf*cm, ft.*lbf): Specified torque - - RemovalREMOVAL PROCEDURE 1. RE
SEE MORE:
How To Proceed With Troubleshooting
CAUTION / NOTICE / HINT HINT:
Use the following procedures to troubleshoot the steering lock system.
*: Use the Techstream.
PROCEDURE 1. VEHICLE BROUGHT TO WORKSHOP
NEXT 2. CUSTOMER PROBLEM ANALYSIS (a) Interview the customer and confirm the problem. Click
Terminals Of Ecu
TERMINALS OF ECU CHECK SLIDING ROOF ECU (SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY) (a) Disconnect the T9 sliding roof ECU (sliding roof drive gear sub-assembly) connector. (b) Measure the resistance and voltage according to the value(s) in the table below. Tester Connection Wiring Color Terminal
