Lexus NX: Inspection
Lexus NX Service Manual / Vehicle Interior / Seat Belt / Front Seat Outer Belt Assembly / Inspection
INSPECTION
PROCEDURE
1. INSPECT FRONT SEAT OUTER BELT ASSEMBLY
| (a) Before installing the front seat outer belt assembly, check the ELR function. NOTICE: Do not disassemble the retractor. (1) When the inclination of the retractor is 15° or less, check that the belt can be pulled from the retractor. When the inclination of the retractor is over 45°, check that the belt locks. If the result is not as specified, replace the front seat outer belt assembly. |
|
READ NEXT:
Rear Center Seat Outer Belt Assembly
ComponentsCOMPONENTS ILLUSTRATION *1 REAR CENTER SEAT OUTER BELT ASSEMBLY *2 SEAT BELT ANCHOR COVER N*m (kgf*cm, ft.*lbf): Specified torque - - RemovalREMOVAL PROCEDURE 1. RE
Removal
REMOVAL PROCEDURE 1. REMOVE REAR SEAT ASSEMBLY (for Manual Seat) Click here 2. REMOVE REAR SEAT ASSEMBLY (for Power Seat) Click here 3. REMOVE REAR SEAT INNER WITH CENTER BELT ASSEMBLY RH (a) f
SEE MORE:
Removal
REMOVAL CAUTION / NOTICE / HINT NOTICE:
When the brake pedal is first depressed after replacing the brake pads or pushing back the disc brake piston, DTC C1214 may be output. As there is no malfunction, clear the DTC.
While the auxiliary battery is connected, even if the power switch is off, th
Installation
INSTALLATION PROCEDURE 1. INSTALL STEERING WHEEL HEATER CONTROL ASSEMBLY (a) Connect the connector to the steering wheel heater control assembly. (b) Install the steering wheel heater control assembly to the lower steering wheel boss cover with the 2 screws. NOTICE: If the heater thermistor comes of
© 2016-2026 Copyright www.lexunx.com
