Lexus NX: Rear Seat Inner Belt Assembly

Lexus NX Service Manual / Vehicle Interior / Seat Belt / Rear Seat Inner Belt Assembly

READ NEXT:

 Removal

REMOVAL PROCEDURE 1. REMOVE REAR SEAT ASSEMBLY (for Manual Seat) Click here 2. REMOVE REAR SEAT ASSEMBLY (for Power Seat) Click here 3. REMOVE REAR SEAT INNER WITH CENTER BELT ASSEMBLY RH (a) f

 Inspection

INSPECTION PROCEDURE 1. INSPECT REAR SEAT INNER WITH CENTER BELT ASSEMBLY RH (a) for Manual Seat: (1) w/o Seat Heater System: Measure the resistance according to the value(s) in the table below. St

 Installation

INSTALLATION PROCEDURE 1. INSTALL REAR SEAT CENTER LAP TYPE BELT ASSEMBLY LH (a) Install the rear seat center lap type belt assembly LH with the nut. Torque: 42 N·m {428 kgf·cm, 31 ft·lbf} NOTI

SEE MORE:

 Operation Check

OPERATION CHECK CHECK POWER SEAT FUNCTION *A for Driver Side *a Slide Function *b Reclining Function *c Rear Lifter Function *d Front Vertical Function *e Lumbar Support Adjustment Function (a) Check the basic functions. (1) Operate the power seat switches and

 Reassembly

REASSEMBLY PROCEDURE 1. INSTALL NO. 2 MOULDING TAPE HINT: When installing the No. 2 moulding tape, heat the front bumper cover and No. 2 moulding tape using a heat light. Use the same procedure described for the other side. Standard: Item Temperature Front Bumper Cover 20 to 30°

© 2016-2026 Copyright www.lexunx.com