Lexus NX: On-vehicle Inspection

ON-VEHICLE INSPECTION

PROCEDURE

1. INSPECT COOLING FAN SYSTEM

(a) Connect the Techstream to the DLC3.

(b) Turn the power switch on (IG).

(c) Turn the Techstream on.

(d) Enter the following menus: Powertrain / Engine and ECT / Active Test / Control the Electric Cooling Fan.

Powertrain > Engine and ECT > Active Test

Tester Display

Control the Electric Cooling Fan

(e) Check the operation of the cooling fans while operating them using the Techstream.

OK:

Tester Operation

Fan Operation

ON

Cooling fans operate

OFF

Cooling fans stop

If the cooling fan motor does not operate, check the cooling fan circuit.

Click here

READ NEXT:

 Cooling Fan Circuit

DESCRIPTION The ECM calculates an appropriate cooling fan speed based on the engine coolant temperature, air conditioning switch condition, refrigerant pressure, hybrid coolant temperature, engine spe

 Cooling System

On-vehicle InspectionON-VEHICLE INSPECTION PROCEDURE 1. INSPECT FOR COOLANT LEAK CAUTION: To avoid the danger of being burned, do not remove the radiator reservoir cap while the engine assembly and r

 Radiator

SEE MORE:

 Installation

INSTALLATION PROCEDURE 1. INSTALL PARKING ASSIST ECU (a) Temporarily install a new nut (A) so that the nut cannot fall, but do not tighten it. *a Nut A *b Nut B Connector (b) Connect the 3 connectors. (c) Insert nut (A) into the hole in the body and slide downward to temporaril

 Removal

REMOVAL CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH and LH sides. The procedure described below is for the LH side. PROCEDURE 1. REMOVE OUTER MIRROR LH Click here 2. REMOVE OUTER MIRROR COVER LH (a) Detach the 6 claws and 2 guides and remove the outer mirror cover L

© 2016-2026 Copyright www.lexunx.com