Lexus NX: Radiator
READ NEXT:
Components
COMPONENTS ILLUSTRATION *A for 2WD *B for AWD *1 HOOD LOCK ASSEMBLY *2 NO. 6 INVERTER BRACKET *3 UPPER RADIATOR SUPPORT SUB-ASSEMBLY *4 FRONT RADIATOR SIDE AIR GUIDE PLAT
On-vehicle Inspection
ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT RESERVOIR CAP (a) Measure the valve opening pressure. *a O-Ring *b Rubber Packing (1) If there are water stains or foreign matter on the O-rin
Removal
REMOVAL PROCEDURE 1. DRAIN ENGINE COOLANT Click here 2. REMOVE FRONT BUMPER REINFORCEMENT SUB-ASSEMBLY Click here 3. DISCONNECT HOOD LOCK ASSEMBLY (a) Detach the 2 clamps and disconnect the ho
SEE MORE:
Antenna Coil Open / Short (B2784)
DESCRIPTION When an open or short circuit is detected in the transponder key amplifier coil built into the power switch, the certification ECU (smart key ECU assembly) stores this DTC. This DTC is also stored as a past DTC. DTC No. Detection Item DTC Detection Condition Trouble Area Note
Removal
REMOVAL CAUTION / NOTICE / HINT CAUTION: Wear protective gloves. Sharp areas on the parts may injure your hands. HINT:
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
PROCEDURE 1. PRECAUTION CAUTION: Be sure to read Precaution thoroughly before
© 2016-2025 Copyright www.lexunx.com
