- - METER NO.1 FUSE
Lexus NX: Parts Location
PARTS LOCATION
ILLUSTRATION
| *1 | AIRBAG ECU ASSEMBLY | *2 | PARKING BRAKE ECU ASSEMBLY |
| *3 | AIR CONDITIONING CONTROL ASSEMBLY | *4 | HYBRID VEHICLE CONTROL ECU |
| *5 | BRAKE BOOSTER WITH MASTER CYLINDER ASSEMBLY (SKID CONTROL ECU) | *6 | ENGINE ROOM RELAY BLOCK |
| *7 | COMBINATION METER ASSEMBLY | *8 | SEAT BELT WARNING LIGHT |
| *9 | INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY
| *10 | MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) |
| *11 | DLC3 | *12 | REAR SEAT BELT WARNING LIGHT |
ILLUSTRATION
| *A | for F-Sports Type | *B | for L-Sports Type |
| *1 | FRONT SEAT INNER BELT ASSEMBLY LH | *2 | FRONT SEAT INNER BELT ASSEMBLY RH |
| *3 | OCCUPANT DETECTION ECU | *4 | FRONT OCCUPANT CLASSIFICATION SENSOR LH |
| *5 | REAR OCCUPANT CLASSIFICATION SENSOR LH | - | - |
ILLUSTRATION
| *A | w/ Seat Heater System | *B | w/o Seat Heater System |
| *1 | REAR DOOR COURTESY LIGHT SWITCH ASSEMBLY LH | *2 | REAR DOOR COURTESY LIGHT SWITCH ASSEMBLY RH |
| *3 | REAR SEAT INNER BELT ASSEMBLY LH | *4 | REAR SEAT INNER WITH CENTER BELT ASSEMBLY RH |
READ NEXT:
System Diagram
SYSTEM DIAGRAM
System Description
SYSTEM DESCRIPTION SEAT BELT WARNING SYSTEM DESCRIPTION HINT: The front seat belt warning light on the combination meter assembly is used for both the driver side seat and front passenger side seat. (
How To Proceed With Troubleshooting
CAUTION / NOTICE / HINT HINT:
Use this procedure to troubleshoot the seat belt warning system.
*: Use the Techstream.
PROCEDURE 1. VEHICLE BROUGHT TO WORKSHOP
NEXT
SEE MORE:
NTSC Disconnected (from Park Assist/Monitoring ECU) (B1535,C1622)
DESCRIPTION This DTC is stored if the radio receiver assembly judges that the signals or signal lines between the television camera assembly and the multi-display assembly are not normal as a result of its self check. DTC No. Detection Item DTC Detection Condition Trouble Area B1535 N
Precaution
PRECAUTION POINTS TO NOTE WHEN SERVICING (a) Pay attention to the following points when servicing. (1) When disconnecting the cable from the negative (-) auxiliary battery terminal, "!" mark may appear on the multi-display assembly. In this case, restore the steering angle neutral point. Click here
© 2016-2026 Copyright www.lexunx.com
