Lexus NX: Power Distribution
Lexus NX Service Manual / Power Source & Network / Power Distribution
READ NEXT:
Components
COMPONENTS ILLUSTRATION *1 DECK FLOOR BOX LH *2 NO. 3 DECK BOARD SUB-ASSEMBLY *3 REAR DECK FLOOR BOX *4 AUXILIARY BATTERY NEGATIVE TERMINAL N*m (kgf*cm, ft.*lbf): Specified
Removal
REMOVAL PROCEDURE 1. REMOVE NO. 3 DECK BOARD SUB-ASSEMBLY Click here 2. REMOVE REAR DECK FLOOR BOX Click here 3. REMOVE DECK FLOOR BOX LH Click here 4. PRECAUTION CAUTION: Be sure to read Precou
SEE MORE:
Inspection
INSPECTION PROCEDURE 1. INSPECT ENGINE COOLANT TEMPERATURE SENSOR *a Component without harness connected (Engine Coolant Temperature Sensor) *b Resistance *c Temperature *d Acceptable Range (a) Partially immerse the sensor in water and warm up the water. (b) Measure the resist
Initialization
INITIALIZATION INITIALIZATION SERVO MOTOR (a) Turn the power switch off. (b) Connect the Techstream to the DLC3. (c) Turn the power switch on (IG). (d) Press the A/C OFF switch. (e) Turn the Techstream on. (f) Enter the following menus: Body Electrical / Air Conditioner / Utility / Servomotor Initia
© 2016-2026 Copyright www.lexunx.com
