Lexus NX: Main Body Ecu
READ NEXT:
Components
COMPONENTS ILLUSTRATION *1 DECK FLOOR BOX LH *2 NO. 3 DECK BOARD SUB-ASSEMBLY *3 REAR DECK FLOOR BOX *4 AUXILIARY BATTERY NEGATIVE TERMINAL N*m (kgf*cm, ft.*lbf): Specified
Removal
REMOVAL PROCEDURE 1. REMOVE NO. 3 DECK BOARD SUB-ASSEMBLY Click here 2. REMOVE REAR DECK FLOOR BOX Click here 3. REMOVE DECK FLOOR BOX LH Click here 4. PRECAUTION CAUTION: Be sure to read Precou
Installation
INSTALLATION PROCEDURE 1. INSTALL MULTIPLEX NETWORK BODY ECU (MAIN BODY ECU) NOTICE:
Make sure that no foreign matter gets on the connecting surfaces.
Do not touch the ECU connector.
(a) Inser
SEE MORE:
Adjustment
ADJUSTMENT CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
It is possible that a headlight assembly is incorrectly installed, affecting headlight aim. Headlight assembly installation should be considered prior to per
Operation Check
OPERATION CHECK CHECK SLIDING ROOF NOTICE:
If the negative battery terminal is disconnected under the following conditions, initialization of the sliding roof drive gear sub-assembly may not be completed. In this case, perform initialization.
Within 2 seconds after roof glass operation stops.
© 2016-2025 Copyright www.lexunx.com
