Lexus NX: Power Point Socket (for Luggage Compartment)
Lexus NX Service Manual / Vehicle Interior / Power Outlets (int) / Power Point Socket (for Luggage Compartment)
READ NEXT:
Components
COMPONENTS ILLUSTRATION *1 DECK TRIM SIDE PANEL ASSEMBLY LH *2 LUGGAGE HOLD BELT STRIKER ASSEMBLY *3 NO. 1 LUGGAGE COMPARTMENT TRIM HOOK *4 REAR DOOR OPENING TRIM WEATHERSTRIP LH
Removal
REMOVAL PROCEDURE 1. REMOVE REAR SEAT ASSEMBLY (a) for Power Seat: Click here (b) for Manual Seat: Click here 2. REMOVE REAR FLOOR FINISH PLATE Click here 3. REMOVE REAR DOOR OPENING TRIM W
Installation
INSTALLATION PROCEDURE 1. INSTALL REAR POWER OUTLET SOCKET COVER (a) Attach the 2 claws to install the rear power outlet socket cover. HINT: Use the same procedure to install the other power outlet so
SEE MORE:
Low Output Signal of Rear Speed Sensor RH (C1273,C1274,C1466,C1467)
DESCRIPTION Each speed sensor detects the wheel speed and sends the signals to the skid control ECU (brake booster with master cylinder assembly). These signals are used for ABS control. DTCs C1273 and C1274 are cleared when the speed sensor sends a wheel speed signal or when Test Mode ends. DTCs C1
Check Bus 5 Line for Short to GND
DESCRIPTION There may be a short circuit between one of the CAN bus lines and GND when there is no resistance between terminal 15 (CA5H) of the central gateway ECU (network gateway ECU) and terminal 4 (CG) of the DLC3, or terminal 16 (CA5L) of the central gateway ECU (network gateway ECU) and termin
© 2016-2024 Copyright www.lexunx.com
