Lexus NX: Removal
REMOVAL
PROCEDURE
1. REMOVE FRONT BUMPER ASSEMBLY
Click here .gif)
2. REMOVE NO. 3 ENGINE ROOM WIRE
Click here
3. REMOVE CLEARANCE LIGHT ASSEMBLY LH
(a) for LED Type Side Turn Signal Light:
Click here
(b) for Bulb Type Side Turn Signal Light:
Click here
4. REMOVE CLEARANCE LIGHT ASSEMBLY RH
HINT:
Use the same procedure described for the LH side.
5. REMOVE HOOD TO FRONT END PANEL SEAL
Click here
6. REMOVE RADIATOR GRILLE SUB-ASSEMBLY
(a) Remove the 8 screws.
(b) Remove the 2 outside moulding retainers.
(c) Detach the 15 claws and 2 guides and remove the radiator grille sub-assembly.
.png) | Screw | .png) | Outside Moulding Retainer |
READ NEXT:
Disassembly
DISASSEMBLY PROCEDURE 1. REMOVE MILLIMETER WAVE RADAR SENSOR ASSEMBLY Click here 2. REMOVE FRONT TELEVISION CAMERA ASSEMBLY (w/ Panoramic View Monitor System) Click here 3. REMOVE FRONT CENTER U
Reassembly
REASSEMBLY PROCEDURE 1. INSTALL NUT (a) Install the 2 nuts. 2. INSTALL RADIATOR GRILLE EMBLEM (a) Attach the claw and guide to install the radiator grille emblem. (b) Ins
Installation
INSTALLATION PROCEDURE 1. INSTALL RADIATOR GRILLE SUB-ASSEMBLY (a) Attach the 15 claws and 2 guides to install the radiator grille sub-assembly. (b) Install the 2 outside moulding retainers. (c) Insta
SEE MORE:
Data List / Active Test
DATA LIST / ACTIVE TEST DATA LIST NOTICE: In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not. HINT: Using the Techstream to read the Data List allows the values or states of
Replacement
REPLACEMENT CAUTION / NOTICE / HINT NOTICE:
When the brake pedal is first depressed after replacing the brake pads or pushing back the disc brake piston, DTC C1214 may be output. As there is no malfunction, clear the DTC.
While the auxiliary battery is connected, even if the power switch is off
© 2016-2026 Copyright www.lexunx.com
