Lexus NX: Precaution
PRECAUTION
PRECAUTION FOR REPLACEMENT
(a) Always prepare a new bulb for immediate replacement. While replacing a bulb, the lens may attract dust and moisture if removed from the vehicle for a long time.
(b) Always replace a bulb with another bulb of the same wattage.
(c) If only replacing the bulb on one side, differences in brightness and lighting color between the right and left sides may occur.
(d) Securely install the socket after bulb replacement. The lens may become cloudy or the light cavity may fill with water through gaps around the socket if the socket is not installed securely.
PRECAUTION WHEN REPLACING HEADLIGHT ECU SUB-ASSEMBLY LH
(a) If the headlight ECU sub-assembly LH has been replaced, it is necessary to synchronize the vehicle information and initialize the headlight ECU sub-assembly LH.
Click here .gif)
READ NEXT:
Parts Location
PARTS LOCATION ILLUSTRATION *1 FRONT DOOR COURTESY LIGHT SWITCH ASSEMBLY LH *2 SHIFT LEVER POSITION SENSOR *3 SIDE TURN SIGNAL LIGHT ASSEMBLY LH *4 SIDE TURN SIGNAL LIGHT ASSEMBLY
System Diagram
SYSTEM DIAGRAM Tail, Stop, Headlight Circuit Turn Signal Circuit
System Description
SYSTEM DESCRIPTION AUTOMATIC LIGHT CONTROL SYSTEM (a) When the headlight dimmer switch is in the AUTO position, the automatic light control system detects ambient light levels and controls the headlig
SEE MORE:
Removal
REMOVAL PROCEDURE 1. REMOVE REAR STABILIZER LINK ASSEMBLY LH (a) Remove the 2 nuts and 2 cushions and disconnect the rear stabilizer link assembly LH from the rear No. 2 suspension arm assembly LH. HINT: If the ball joint turns together with the nut, use a 6 mm hexagon wrench to hold the stud.
Calibration
CALIBRATION DESCRIPTION (a) After replacing any VSC related components or performing wheel alignment adjustment, clear and read the sensor calibration data. Refer to the table below and then perform the necessary operation according to the part to be replaced in order to perform calibration. Part
