Lexus NX manuals

Lexus NX: Precaution

Lexus NX Service Manual / Vehicle Exterior / Wiper / Washer / Wiper And Washer System / Precaution

PRECAUTION

PRECAUTION OF WASHER NOZZLE ADJUSTMENT

(a) Do not clean or adjust the washer nozzle with a safety pin, etc. because:

(1) The washer nozzle tip is made of resin and could be damaged.

(2) Adjustment is not necessary for this spray type washer nozzle. If it is necessary to change the nozzle angle, replace the washer nozzle with one that has a different nozzle angle.

for Front Side: Click here

for Rear Side: Click here

(b) If the washer nozzle is clogged with wax, etc., bring the vehicle to the workshop.

PRECAUTION OF RAIN SENSOR (w/ Rain Sensor)

(a) If a water repellent coating is applied to the windshield glass, the rain sensor cannot properly detect the amount of rain and the rain sensing wipers may not operate properly.

READ NEXT:

 Parts Location

PARTS LOCATION ILLUSTRATION *A w/ Rain Sensor *B w/ Headlight Cleaner System *C for Triple Beam Headlight *D for Single Beam Headlight *1 WINDSHIELD WIPER MOTOR ASSEMBLY *2

 System Diagram

SYSTEM DIAGRAM FRONT WIPER AND WASHER SYSTEM (w/ Rain Sensor) FRONT WIPER AND WASHER SYSTEM (w/o Rain Sensor) REAR WIPER AND WASHER SYSTEM HEADLIGHT CLEANER SYSTEM (w/ Headlight Cleaner System, fo

 System Description

SYSTEM DESCRIPTION WASHER-LINKED FUNCTION (a) This system operates the front wipers at low speed immediately after spraying a jet of washer fluid when the front washer switch is turned on for 0.3 seco

SEE MORE:

 Replacement

REPLACEMENT PROCEDURE 1. REPLACE INTAKE VALVE GUIDE BUSH (a) Heat the cylinder head sub-assembly to approximately 80 to 100°C (176 to 212°F). (b) Place the cylinder head sub-assembly on wooden blocks. (c) Using SST and a hammer, tap out the intake valve guide bush. SST: 09201-01055 SST: 09950-7

 Installation

INSTALLATION PROCEDURE 1. INSTALL SHIFT LEVER POSITION SENSOR (a) Install the shift lever position sensor to the manual valve shaft. (b) Temporarily install the 2 bolts. (c) Install the lock plate and tighten the lock nut. Torque: 6.9 N·m {70 kgf·cm, 61 in·lbf} (d) Temporarily install the contro

© 2016-2026 Copyright www.lexunx.com