Lexus NX: Wiper And Washer System
- Precaution
- Parts Location
- System Diagram
- System Description
- How To Proceed With Troubleshooting
- Problem Symptoms Table
- Terminals Of Ecu
- Fail-safe Chart
- Data List / Active Test
- Headlight Cleaner Motor and Relay Circuit
- Washer Fluid Level Warning Switch Circuit
READ NEXT:
Precaution
PRECAUTION PRECAUTION OF WASHER NOZZLE ADJUSTMENT (a) Do not clean or adjust the washer nozzle with a safety pin, etc. because: (1) The washer nozzle tip is made of resin and could be damaged. (2) Adj
Parts Location
PARTS LOCATION ILLUSTRATION *A w/ Rain Sensor *B w/ Headlight Cleaner System *C for Triple Beam Headlight *D for Single Beam Headlight *1 WINDSHIELD WIPER MOTOR ASSEMBLY *2
System Diagram
SYSTEM DIAGRAM FRONT WIPER AND WASHER SYSTEM (w/ Rain Sensor) FRONT WIPER AND WASHER SYSTEM (w/o Rain Sensor) REAR WIPER AND WASHER SYSTEM HEADLIGHT CLEANER SYSTEM (w/ Headlight Cleaner System, fo
SEE MORE:
Initialization
INITIALIZATION DESCRIPTION (a) Perform initialization and calibration of the linear solenoid valve when the brake booster with master cylinder assembly, brake pedal stroke sensor assembly or brake pedal is replaced. Follow the procedure to perform initialization. HINT:
If there is a problem with
Removal
REMOVAL PROCEDURE 1. REMOVE NO. 3 DECK BOARD SUB-ASSEMBLY Click here 2. REMOVE REAR DECK FLOOR BOX Click here 3. REMOVE DECK FLOOR BOX LH Click here 4. PRECAUTION CAUTION: Be sure to read Precaution thoroughly before servicing. Click here NOTICE: After the power switch is turned off, there m
© 2016-2026 Copyright www.lexunx.com
