Lexus NX: Precaution
PRECAUTION
PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL
NOTICE:
-
After the power switch is turned off, there may be a waiting time before disconnecting the negative (-) auxiliary battery terminal.
Click here
.gif)
-
When disconnecting and reconnecting the auxiliary battery
Click here
HINT:
When disconnecting and reconnecting the auxiliary battery, there is an automatic learning function that completes learning when the respective system is used.
Click here
DOOR CONTROL RECEIVER EXPRESSIONS
(a) The type of door control receiver used on this model differs according to the specifications of the vehicle. The expressions listed in the table below are used in this section.
| Vehicle Specification | Part Name in Manual | Actual Part Name |
|---|---|---|
| w/ Tire Pressure Warning System | Door control receiver | Electrical key & TPMS receiver assembly |
PRECAUTION WHEN USING TECHSTREAM
(a) When using the Techstream with the power switch off, connect the Techstream to the DLC3 and turn a courtesy light switch on and off at intervals of 1.5 seconds or less until communication between the Techstream and the vehicle begins. Then select the vehicle type under manual mode and enter the following menus: Body Electrical / Smart Access. While using the Techstream, periodically turn a courtesy light switch on and off at intervals of 1.5 seconds or less to maintain communication between the Techstream and the vehicle.
PRECAUTION FOR REGISTRATION
(a) If replacing any of the following parts, refer to the registration procedures.
(1) Certification ECU (smart key ECU assembly)
(2) Steering lock ECU (steering lock actuator assembly)
(3) Electrical key transmitter sub-assembly
(4) ID code box (immobiliser code ECU)
(5) Main body ECU (multiplex network body ECU)
(6) Hybrid vehicle control ECU
(7) DCM (telematics transceiver)*
- *: for Lexus Enform Remote Compatible Type
READ NEXT:
Parts Location
PARTS LOCATION ILLUSTRATION *1 NO. 1 ENGINE ROOM RELAY BLOCK - IG2-MAIN RELAY *2 NO. 2 ENGINE ROOM RELAY BLOCK - IG1 RELAY *3 SKID CONTROL ECU (BRAKE BOOSTER WITH MASTER CYLINDER ASSEM
System Diagram
SYSTEM DIAGRAM Component Outline Power switch
Transponder key amplifier
Turns on the power and starts the hybrid control system.
Contains a built-in transponder key amplifier t
System Description
SYSTEM DESCRIPTION SYSTEM FUNCTION Function Outline Push-button start function When the electrical key transmitter sub-assembly is brought into the vehicle and verified, this function chang
SEE MORE:
Speaker Circuit
DESCRIPTION If there is a short in a speaker circuit, the stereo component amplifier assembly detects it and stops output to the speakers. As a result, sound cannot be heard from the speakers even if there is no malfunction in the stereo component amplifier assembly, DCM (telematics transceiver)* or
Hybrid Battery Voltage System Isolation Fault (P0AA6-526,P0AA6-611,P0AA6-612,P0AA6-613,P0AA6-614,P0AA6-655)
DESCRIPTION The hybrid vehicle control ECU monitors the battery voltage sensor and detects insulation malfunctions in the high-voltage system. DTC No. Detection Item DTC Detection Condition Trouble Area MIL Warning Indicate P0AA6-526 Hybrid Battery Voltage System Isolation Fault
