Lexus NX manuals

Lexus NX: Problem Symptoms Table

Lexus NX Service Manual / Engine & Hybrid System / Cruise Control / Front Camera System / Problem Symptoms Table

PROBLEM SYMPTOMS TABLE

HINT:

  • Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
  • Inspect the fuses and relays related to this system before inspecting the suspected areas below.
Front Camera System

Symptom

Suspected Area

Link

"Front Camera Unavailable See Owner's Manual" is displayed

Vehicle control history (front camera system)

Check the vehicle control history of the front camera system

"Front Camera Unavailable" is displayed
  • Vehicle control history (front camera system)
  • Vehicle control history (pre-collision system)
  • Check the vehicle control history of the front camera system

  • Check the vehicle control history of the pre-collision system

READ NEXT:

 Terminals Of Ecu

TERMINALS OF ECU CHECK FORWARD RECOGNITION CAMERA NOTICE: DTCs may be output when connectors are disconnected during inspection. Therefore, be sure to clear the DTCs using the Techstream once the i

 Diagnosis System

DIAGNOSIS SYSTEM DIAGNOSIS FUNCTION (a) The front camera system does not have a notification function such as a warning light when a DTC is detected. When a malfunction occurs, it stores a DTC and sen

 Dtc Check / Clear

DTC CHECK / CLEAR CHECK DTC (a) Connect the Techstream to the DLC3. (b) Turn the power switch on (IG). (c) Turn the Techstream on. (d) Enter the following menus: Chassis / Front Recognition Camera / T

SEE MORE:

 Rear Door Courtesy Switch Circuit

DESCRIPTION The fold seat control ECU receives the switch operation signal, driving condition signal and rear door open/close signal. Then the fold seat control ECU actives the rear seat according to these signals. WIRING DIAGRAM PROCEDURE 1. INSPECT REAR DOOR COURTESY LIGHT SWITCH ASSEMBLY

 Disassembly

DISASSEMBLY CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH and LH sides. The following procedure is for the LH side. PROCEDURE 1. REMOVE CYLINDER BOOT (a) Using a screwdriver with its wrapped with protective tape, remove the piston seal from the disc brake cylinder assemb

© 2016-2026 Copyright www.lexunx.com