Lexus NX: Problem Symptoms Table
PROBLEM SYMPTOMS TABLE
HINT:
-
Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
-
Inspect the fuses and relays related to this system before inspecting the suspected areas below.
Front Radar Sensor System
| Symptom | Suspected Area | Link |
| "Pre-Collision System Unavailable Clean Sensor" is displayed | Vehicle Control History | |
READ NEXT:
TERMINALS OF ECU NOTICE:
Turning the power switch on (IG) with connectors disconnected may cause DTCs to be stored. Make sure to clear the DTCs after inspection has been performed.
Do not apply e
DIAGNOSIS SYSTEM DIAGNOSIS FUNCTION (a) If a malfunction is detected in the millimeter wave radar sensor assembly, the millimeter wave radar sensor assembly stores DTCs without directly informing the
DTC CHECK / CLEAR CHECK DTC (a) Connect the Techstream to the DLC3. (b) Turn the power switch on (IG). (c) Turn the Techstream on. (d) Enter the following menus: Body Electrical / Front Radar Sensor /
SEE MORE:
MONITOR DESCRIPTION DTC P0630 is stored when the Vehicle Identification Number (VIN) is not stored in the ECM or the input VIN is not accurate. DTC No. Detection Item DTC Detection Condition Trouble Area MIL Memory P0630 VIN not Programmed or Mismatch - ECM / PCM Either of the f
DESCRIPTION The rear center ultrasonic sensor (RRC sensor) is installed to the rear bumper. The clearance warning ECU assembly detects obstacles based on signals received from the rear center ultrasonic sensor (RRC sensor). If the rear center ultrasonic sensor (RRC sensor) has an open circuit or oth
© 2016-2026 Copyright www.lexunx.com
