Lexus NX: Components
COMPONENTS
ILLUSTRATION
| *1 | BLIND SPOT MONITOR BUZZER | *2 | DECK TRIM SIDE PANEL ASSEMBLY RH |
| *3 | LUGGAGE HOLD BELT STRIKER ASSEMBLY | *4 | NO. 1 LUGGAGE COMPARTMENT TRIM HOOK |
| *5 | REAR DOOR OPENING TRIM WEATHERSTRIP RH | *6 | REAR FLOOR FINISH PLATE |
| *7 | ROPE HOOK ASSEMBLY | *8 | UPPER DECK TRIM SIDE BOARD RH |
READ NEXT:
Removal
REMOVAL PROCEDURE 1. REMOVE REAR SEAT ASSEMBLY (a) for Manual Seat: Click here (b) for Power Seat: Click here 2. REMOVE REAR FLOOR FINISH PLATE Click here 3. DISCONNECT REAR DOOR OPENING TRIM W
Installation
INSTALLATION PROCEDURE 1. INSTALL BLIND SPOT MONITOR BUZZER (a) Attach the clamp to install the blind spot monitor buzzer. (b) Connect the connector. 2. INSTALL DECK TRIM SIDE PANEL ASSEMBLY RH Click
Television Camera (for Front)
ComponentsCOMPONENTS ILLUSTRATION *1 FRONT TELEVISION CAMERA ASSEMBLY - - RemovalREMOVAL PROCEDURE 1. PRECAUTION Click here 2. REMOVE FRONT BUMPER COVER (a) for Sport Package: Click h
SEE MORE:
Operation Check
OPERATION CHECK AUTOMATIC HIGH BEAM SYSTEM OPERATION CHECK (a) Check the operation of the automatic high beam indicator light. *a Automatic High Beam Indicator Light NOTICE: If the forward recognition camera cannot correctly recognize the front due to bad weather (dense fog, etc.) or obstru
Drive Motor "B" Control Module (P0A1C-713)
DESCRIPTION The MG ECU, which is built into the inverter with converter assembly, monitors its internal operation and will store DTCs if the system is malfunctioning. If any of the following DTCs are output, replace the inverter with converter assembly. DTC No. Detection Item DTC Detection Co
© 2016-2026 Copyright www.lexunx.com
