Lexus NX: Rear Right Center Sensor Malfunction (C1AE8)
DESCRIPTION
The rear center ultrasonic sensor (RRC sensor) is installed to the rear bumper. The clearance warning ECU assembly detects obstacles based on signals received from the rear center ultrasonic sensor (RRC sensor). If the rear center ultrasonic sensor (RRC sensor) has an open circuit or other malfunction, it will not function normally.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| C1AE8 | Rear Right Center Sensor Malfunction | A malfunction of the rear center ultrasonic sensor (RRC sensor). |
|
CAUTION / NOTICE / HINT
NOTICE:
If DTCs are output after repairs, turn the power switch on (IG) and the intuitive parking assist system on. Then clear the DTCs.
Click here .gif)
PROCEDURE
| 1. | CHECK DTC OUTPUT |
(a) Check for DTCs.
Click here
| Result | Proceed to |
|---|---|
| No DTCs are output | A |
| Only DTC C1AE8 is output | B |
| DTC C1AE8 and C1AED are output | C |
| A | .gif) | USE SIMULATION METHOD TO CHECK |
| C | | GO TO DTC (C1AED) |
|
.gif)
| 2. | REPLACE REAR CENTER ULTRASONIC SENSOR (RRC SENSOR) |
(a) Replace the rear center ultrasonic sensor (RRC sensor) with a known good one.
Click here
HINT:
All of the sensors are interchangeable. To confirm whether a sensor is functioning normally, switch it with a known good sensor from the other end of the vehicle.
|
| 3. | CHECK DTC OUTPUT |
(a) Clear the DTCs.
Click here
(b) Check for DTCs.
Click here
| Result | Proceed to |
|---|---|
| No DTCs are output | A |
| DTC C1AE8 is output | B |
| A | | END (REAR CENTER ULTRASONIC SENSOR [RRC SENSOR] WAS DEFECTIVE) |
| B | | REPLACE CLEARANCE WARNING ECU ASSEMBLY |
READ NEXT:
Rear Right Sensor Malfunction (C1AE9)
DESCRIPTION The rear corner ultrasonic sensor (RR sensor) is installed to the rear bumper. The clearance warning ECU assembly detects obstacles based on signals received from the rear corner ultrasoni
Front Sensor Communication Malfunction (C1AEC)
DESCRIPTION This DTC is stored when there is an open or short circuit in the communication line between the front sensors and the ECU, or when there is a malfunction in a front sensor. DTC No. De
Rear Sensor Communication Malfunction (C1AED)
DESCRIPTION This DTC is stored when there is an open or short circuit in the communication line between the rear sensors and the ECU, or when there is a malfunction in a rear sensor. DTC No. Dete
SEE MORE:
Installation
INSTALLATION CAUTION / NOTICE / HINT HINT: Perform "Inspection After Repairs" after replacing the air fuel ratio sensor. Click here PROCEDURE 1. INSTALL AIR FUEL RATIO SENSOR HINT: Perform "Inspection After Repairs" after replacing the air fuel ratio sensor. Click here *a Torque Wrench Ful
Maintenance and care
Maintenance and care
Cleaning and protecting the vehicle
exterior
Perform cleaning in a manner
appropriate to each component
and its material.
Cleaning instructions
Working from top to bottom, liberally
apply water to the vehicle body,
wheel wells and underside of the
vehicle to remo
