Lexus NX: Rear Trailing Arm
READ NEXT:
Components
COMPONENTS ILLUSTRATION *A w/ AVS - - *1 NO. 1 FLOOR UNDER COVER *2 PARKING BRAKE WIRE ASSEMBLY *3 REAR SHOCK ABSORBER ASSEMBLY LH *4 REAR TRAILING ARM ASSEMBLY LH *5
Removal
REMOVAL CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
PROCEDURE 1. REMOVE REAR WHEEL Click here 2. DISCONNECT R
Installation
INSTALLATION CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
PROCEDURE 1. TEMPORARILY INSTALL REAR TRAILING ARM ASS
SEE MORE:
Disassembly
DISASSEMBLY PROCEDURE 1. REMOVE BACK DOOR UPPER OUTSIDE GARNISH LH (a) Remove the screw and back door upper outside garnish LH. 2. REMOVE BACK DOOR UPPER OUTSIDE GARNISH RH HINT: Use the same procedure described for the LH side. 3. REMOVE BACK DOOR NO. 1 GARNISH RETAINER (a) Remove
Disassembly
DISASSEMBLY CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
PROCEDURE 1. REMOVE NO. 3 MOULDING TAPE (a) Remove the No. 3 moulding tape. HINT: Do not pull on the No. 3 moulding tape. Instead, roll the tape up with y
© 2016-2026 Copyright www.lexunx.com
