Lexus NX: Installation
INSTALLATION
CAUTION / NOTICE / HINT
HINT:
- Use the same procedure for the RH and LH sides.
- The procedure listed below is for the LH side.
PROCEDURE
1. TEMPORARILY INSTALL REAR TRAILING ARM ASSEMBLY LH
(a) Temporarily install the rear trailing arm assembly LH to the rear suspension arm bracket with the bolt and nut.
(b) Install the rear trailing arm assembly LH to the vehicle with the 3 bolts.
Torque:
80 N·m {816 kgf·cm, 59 ft·lbf}
(c) Install the rear trailing arm assembly LH to the rear axle carrier with the 2 bolts.
Torque:
200 N·m {2039 kgf·cm, 148 ft·lbf}
2. TEMPORARILY INSTALL REAR SHOCK ABSORBER ASSEMBLY LH
Click here .gif)
3. CONNECT REAR SPEED SENSOR LH
(a) w/ AVS:
Click here
(b) w/o AVS:
Click here
4. CONNECT PARKING BRAKE WIRE ASSEMBLY NO.1
Click here
5. STABILIZE SUSPENSION
Click here
6. TIGHTEN REAR TRAILING ARM ASSEMBLY LH
(a) Tighten the nut.
Torque:
150 N·m {1530 kgf·cm, 111 ft·lbf}
7. TIGHTEN REAR SHOCK ABSORBER ASSEMBLY LH
Click here
8. INSTALL NO. 1 FLOOR UNDER COVER
Click here
9. INSTALL REAR WHEEL
Click here
10. INSPECT AND ADJUST REAR WHEEL ALIGNMENT
Click here
11. CHECK FOR SPEED SENSOR SIGNAL
Click here
12. PERFORM INITIALIZATION
Click here
READ NEXT:
Components
COMPONENTS ILLUSTRATION *A w/o AVS *B w/ AVS *1 REAR SPEED SENSOR LH *2 REAR SUSPENSION ARM COVER LH *3 REAR UPPER CONTROL ARM ASSEMBLY LH *4 PARKING BRAKE WIRE BRACKET
Removal
REMOVAL CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
PROCEDURE 1. REMOVE REAR WHEEL Click here 2. REMOVE REAR
SEE MORE:
Internal Control Module Software Incompatibility Not Programmed (U030051,U030057)
DESCRIPTION
The forward recognition camera receives vehicle information (Conv/HV) from the hybrid vehicle control ECU via the CAN communication line.
When the forward recognition camera is unable to determine the vehicle information (Conv/HV) from the vehicle information (Conv/HV) sent from the
DC / DC Converter Performance (P0A94-550,P0E32-564)
DTC SUMMARY MALFUNCTION DESCRIPTION These DTCs indicate a malfunction inside the inverter for the motor. The cause of this malfunction may be one of the following: Internal inverter malfunction
Internal circuit malfunction in the inverter for the motor
Malfunction in the sensors for inverter co
