Lexus NX manuals

Lexus NX: Relay

Lexus NX Service Manual / Engine & Hybrid System / 2ar-fxe (cooling) / Relay

On-vehicle Inspection

ON-VEHICLE INSPECTION

PROCEDURE

1. INSPECT COOLING FAN RELAY (FAN NO. 1)

(a) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection

Condition

Specified Condition

3 - 5

Battery voltage not applied to terminals 1 and 2

10 kΩ or higher

Battery voltage applied to terminals 1 and 2

Below 1 Ω

If the result is not as specified, replace the cooling fan relay.

READ NEXT:

 Thermostat

ComponentsCOMPONENTS ILLUSTRATION *1 THERMOSTAT *2 WATER INLET *3 GASKET - - N*m (kgf*cm, ft.*lbf): Specified torque ● Non-reusable part RemovalREMOVAL PROCEDURE

 Water Pump

 Components

COMPONENTS ILLUSTRATION *1 ENGINE WATER PUMP ASSEMBLY *2 FAN AND GENERATOR V BELT *3 RADIATOR RESERVE TANK ASSEMBLY *4 V-RIBBED BELT TENSIONER ASSEMBLY *5 WATER BY-PASSS HOSE

SEE MORE:

 Removal

REMOVAL CAUTION / NOTICE / HINT CAUTION: Wear protective gloves. Sharp areas on the parts may injure your hands. PROCEDURE 1. REMOVE TONNEAU COVER ASSEMBLY Click here 2. REMOVE DECK BOARD ASSEMBLY Click here 3. REMOVE BENCH TYPE REAR SEAT CUSHION ASSEMBLY (a) Lift the front end of the rear

 Parts Location

PARTS LOCATION ILLUSTRATION *1 FORWARD RECOGNITION CAMERA *2 FORWARD RECOGNITION WITH HEATER HOOD SUB-ASSEMBLY *3 BRAKE BOOSTER WITH MASTER CYLINDER ASSEMBLY - SKID CONTROL ECU - - ILLUSTRATION *1 STEERING SENSOR *2 COMBINATION METER ASSEMBLY *3 MULTIPLEX NETWO

© 2016-2026 Copyright www.lexunx.com