Lexus NX: System Diagram
Lexus NX Service Manual / Engine & Hybrid System / Cruise Control / Front Radar Sensor System / System Diagram
SYSTEM DIAGRAM
SYSTEM DIAGRAM
LOCAL CAN CIRCUIT
READ NEXT:
How To Proceed With Troubleshooting
CAUTION / NOTICE / HINT HINT:
Before performing troubleshooting for the front radar sensor system, perform troubleshooting for the pre-collision system.
Click here
*: Use the Techstream.
PRO
Utility
UTILITY NOTICE:
When replacing the millimeter wave radar sensor assembly, always replace it with a new one. If a millimeter wave radar sensor assembly which was installed to another vehicle is used
Problem Symptoms Table
PROBLEM SYMPTOMS TABLE HINT:
Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of
SEE MORE:
Removal
REMOVAL PROCEDURE 1. REMOVE CONSOLE ARMREST ASSEMBLY Click here 2. REMOVE UPPER NO. 2 CONSOLE PANEL GARNISH Click here 3. REMOVE INSTRUMENT SIDE PANEL LH Click here 4. REMOVE NO. 1 INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY Click here 5. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-AS
Generator Position Sensor Angle Malfunction (P1CAC-200,P1CAF-792,P1CB2-793)
DESCRIPTION The MG ECU, which is built into the inverter with converter assembly, monitors its internal operation and detects the following malfunctions. DTC No. Detection Item DTC Detection Condition Trouble Area MIL Warning Indicate P1CAC-200 Generator Position Sensor Angle Malf
© 2016-2025 Copyright www.lexunx.com
