Lexus NX: Ultrasonic Sensor (for Rear)
Lexus NX Service Manual / Audio & Visual & Telematics / Park Assist / Monitoring / Ultrasonic Sensor (for Rear)
READ NEXT:
Components
COMPONENTS ILLUSTRATION *A w/ Hands Free Power Back Door - - *1 NO. 2 LUGGAGE ROOM WIRE *2 REAR CENTER ULTRASONIC SENSOR *3 REAR CENTER ULTRASONIC SENSOR RETAINER *4 REAR
Removal
REMOVAL PROCEDURE 1. PRECAUTION Click here 2. REMOVE REAR BUMPER COVER Click here 3. REMOVE NO. 2 LUGGAGE ROOM WIRE Click here 4. REMOVE REAR CORNER ULTRASONIC SENSOR (a) Detach the 2 claws a
Inspection
INSPECTION PROCEDURE 1. INSPECT REAR CENTER ULTRASONIC SENSOR (a) Measure the resistance according to the value(s) in the table below. Standard Resistance: Tester Connection Condition Speci
SEE MORE:
Dtc Check / Clear
DTC CHECK / CLEAR CHECK DTC (a) Connect the Techstream to the DLC3. (b) Turn the power switch on (IG). (c) Turn the Techstream on. (d) Enter the following menus: Body Electrical / Sliding Roof / Trouble Codes. Body Electrical > Sliding Roof > Trouble Codes (e) Check the details of the DTC(s).
Removal
REMOVAL PROCEDURE 1. REMOVE HYBRID VEHICLE TRANSAXLE ASSEMBLY Click here 2. REMOVE TRANSMISSION INPUT DAMPER ASSEMBLY (a) Using SST, hold the crankshaft pulley assembly. SST: 09213-54015 SST: 09330-00021 HINT: Part number of installation bolt for SST (crankshaft pulley holding tool): 91551-806
© 2016-2026 Copyright www.lexunx.com
