Lexus NX: Utility
UTILITY
NOTICE:
-
If the forward recognition camera has been replaced with a new one or the windshield glass has been removed and installed, it is necessary to perform forward recognition camera adjustment.
HINT:
Forward recognition camera adjustment can be performed by using either "One Time Recognition" or "Sequential Recognition".
One Time Recognition:
Click here
.gif)
Sequential Recognition:
Click here
- When replacing the windshield glass equipped with the forward recognition camera, be sure to replace it with a genuine windshield glass for the forward recognition camera. A windshield glass other than a genuine windshield glass for the forward recognition camera does not have a camera installation bracket. Therefore, the forward recognition camera cannot be installed. If the forward recognition camera is mounted on a windshield glass that is not a genuine windshield glass for the forward recognition camera, the systems using the forward recognition camera may not operate properly because of the transmittance of the windshield glass and the shape of black ceramic parts.
STORE RECOGNITION CAMERA/TARGET POSITIONS
HINT:
The purpose of this Utility is to raise the recognition accuracy of the camera by calibrating the internal data derived from the "Recognition Camera/Target Position Memory" of the forward recognition camera.
(a) According to the display on the Techstream, perform "Recognition Camera/Target Position Memory".
Chassis > Front Recognition Camera > Utility| Tester Display |
|---|
| Recognition Camera/Target Position Memory |
HINT:
- For the procedure, refer to the forward recognition camera adjustment.
-
Forward recognition camera adjustment can be performed by using either "One Time Recognition" or "Sequential Recognition".
One Time Recognition:
Click here
Sequential Recognition:
Click here
BEAM AXIS LEARNING
HINT:
The purpose of this Utility is to make the forward recognition camera store the information necessary to perform "Recognition Camera Axis Adjust".
(a) According to the display on the Techstream, perform "Recognition Camera Axis Adjust".
Chassis > Front Recognition Camera > Utility| Tester Display |
|---|
| Recognition Camera Axis Adjust |
HINT:
- For the procedure, refer to the forward recognition camera adjustment.
-
Forward recognition camera adjustment can be performed by using either "One Time Recognition" or "Sequential Recognition".
One Time Recognition:
Click here
Sequential Recognition:
Click here
READ NEXT:
Problem Symptoms Table
PROBLEM SYMPTOMS TABLE HINT:
Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of
Terminals Of Ecu
TERMINALS OF ECU CHECK FORWARD RECOGNITION CAMERA NOTICE:
DTCs may be output when connectors are disconnected during inspection. Therefore, be sure to clear the DTCs using the Techstream once the i
Diagnosis System
DIAGNOSIS SYSTEM DIAGNOSIS FUNCTION (a) The front camera system does not have a notification function such as a warning light when a DTC is detected. When a malfunction occurs, it stores a DTC and sen
SEE MORE:
Installation
INSTALLATION PROCEDURE 1. INSTALL FRONT STABILIZER BAR BUSHING LH *1 Stopper Front of the Vehicle (a) Install the front stabilizer bar bushing to the front stabilizer bar as shown in the illustration. NOTICE:
Install the front stabilizer bar bushing so that the cutouts face the re
Removal
REMOVAL PROCEDURE 1. PRECAUTION NOTICE:
Be sure to read Precaution thoroughly before servicing.
Click here
Handle components indoors as much as possible to prevent foreign matter from entering and adhering to headlight assembly components.
Do not reuse parts which have reduced fastening abi
