Lexus NX: Vehicle Specifications have not been Stored (B2451)
DESCRIPTION
This DTC is output if the vehicle variation information is not written to the headlight ECU sub-assembly LH.
The headlight ECU sub-assembly LH outputs DTC B2451.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| B2451 | Vehicle Specifications have not been Stored | Vehicle specification information not written | Headlight ECU sub-assembly LH |
CAUTION / NOTICE / HINT
NOTICE:
After the headlight ECU sub-assembly LH is replaced, vehicle information registration and initialization are necessary.
Click here .gif)
PROCEDURE
| 1. | VEHICLE INFORMATION HEADLIGHT ECU SUB-ASSEMBLY LH |
(a) Register vehicle information for the headlight ECU sub-assembly LH.
Click here
|
.gif)
| 2. | CHECK FOR DTC |
(a) Clear the DTCs.
Click here
(b) Turn the power switch on (IG).
(c) Check for DTCs.
Click here
OK:
DTC B2451 output does not occur.
| OK | .gif) | END (NORMAL AFTER VEHICLE INFORMATION REGISTERED) |
| NG | | REPLACE HEADLIGHT ECU SUB-ASSEMBLY LH |
READ NEXT:
Right Headlight ECU Variation Error (B2455)
DESCRIPTION This DTC is output when a headlight ECU sub-assembly RH that is incompatible with the vehicle is installed. The headlight ECU sub-assembly LH outputs DTC B2455. DTC No. Detection Item
Left Headlight ECU Variation Error (B2456)
DESCRIPTION This DTC is output when a headlight ECU sub-assembly LH that is incompatible with the vehicle is installed. The headlight ECU sub-assembly LH outputs DTC B2456. DTC No. Detection Item
Control Module Communication Bus "A" Off (U0073,U0100,U0101,U0126,U0129,U0142,U0155,U0293)
DESCRIPTION DTC No. Detection Item DTC Detection Condition Trouble Area U0073 Control Module Communication Bus "A" Off Bus off condition is detected. CAN communication system U0
SEE MORE:
Fuel Level Sensor "A" Circuit Range / Performance (P0461)
DESCRIPTION The fuel sender gauge is located inside the fuel tank and measures the amount of fuel. The fuel sender gauge converts the fuel level in the fuel tank into a output value, and outputs this value. The ECM determines when it is necessary to refuel the vehicle based on changes in the output
ABS Warning Light Remains ON
DESCRIPTION The skid control ECU (brake booster with master cylinder assembly) is connected to the combination meter assembly via CAN communication. If any of the following is detected, the ABS warning light remains on:
The skid control ECU (brake booster with master cylinder assembly) connector
