Lexus NX: Air Fuel Ratio Sensor
READ NEXT:
Components
COMPONENTS ILLUSTRATION *1 AIR FUEL RATIO SENSOR *2 INVERTER RESERVE TANK ASSEMBLY *3 NO. 1 EXHAUST MANIFOLD HEAT INSULATOR *4 WIRE HARNESS *5 RADIATOR HOSE CLAMP - -
Removal
REMOVAL PROCEDURE 1. DISCONNECT WIRE HARNESS Click here 2. REMOVE NO. 1 EXHAUST MANIFOLD HEAT INSULATOR Click here 3. DISCONNECT INVERTER RESERVE TANK ASSEMBLY Click here 4. REMOVE AIR FUEL RA
Inspection
INSPECTION PROCEDURE 1. INSPECT AIR FUEL RATIO SENSOR (a) Measure the resistance according to the value(s) in the table below. Standard Resistance: Tester Connection Condition Specified Con
SEE MORE:
Precaution
PRECAUTION FUEL RECEIVER GAUGE OPERATION (a) OPERATION The combination meter assembly uses the fuel injection volume signal from the ECM, fuel sender gauge assembly to detect the amount of fuel remaining in the fuel tank assembly. Each gauge assembly has a variable resistor whose resistance changes
Data List / Active Test
DATA LIST / ACTIVE TEST DATA LIST NOTICE: In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not. HINT: Using the Techstream to read the Data List allows the values or states of
© 2016-2026 Copyright www.lexunx.com
