Lexus NX: Components
COMPONENTS
ILLUSTRATION
| *1 | AIR FUEL RATIO SENSOR | *2 | INVERTER RESERVE TANK ASSEMBLY |
| *3 | NO. 1 EXHAUST MANIFOLD HEAT INSULATOR | *4 | WIRE HARNESS |
| *5 | RADIATOR HOSE CLAMP | - | - |
.png) | N*m (kgf*cm, ft.*lbf): Specified torque | * | For use with SST |
READ NEXT:
Removal
REMOVAL PROCEDURE 1. DISCONNECT WIRE HARNESS Click here 2. REMOVE NO. 1 EXHAUST MANIFOLD HEAT INSULATOR Click here 3. DISCONNECT INVERTER RESERVE TANK ASSEMBLY Click here 4. REMOVE AIR FUEL RA
Inspection
INSPECTION PROCEDURE 1. INSPECT AIR FUEL RATIO SENSOR (a) Measure the resistance according to the value(s) in the table below. Standard Resistance: Tester Connection Condition Specified Con
Installation
INSTALLATION CAUTION / NOTICE / HINT HINT: Perform "Inspection After Repairs" after replacing the air fuel ratio sensor. Click here PROCEDURE 1. INSTALL AIR FUEL RATIO SENSOR HINT: Perform "Inspecti
SEE MORE:
Components
COMPONENTS ILLUSTRATION *1 DECK FLOOR BOX LH *2 NO. 3 DECK BOARD SUB-ASSEMBLY *3 REAR DECK FLOOR BOX *4 NEGATIVE AUXILIARY BATTERY TERMINAL N*m (kgf*cm, ft.*lbf): Specified torque - - ILLUSTRATION *1 FRONT DOOR ARMREST SET BRACKET LH *2 FRONT DOOR BELT MOU
Data List / Active Test
DATA LIST / ACTIVE TEST DATA LIST NOTICE: In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not. HINT: Using the Techstream to read the Data List allows the values or states of
© 2016-2026 Copyright www.lexunx.com
