Lexus NX: Installation

INSTALLATION

CAUTION / NOTICE / HINT

HINT:

Perform "Inspection After Repairs" after replacing the air fuel ratio sensor.

Click here

PROCEDURE

1. INSTALL AIR FUEL RATIO SENSOR

HINT:

Perform "Inspection After Repairs" after replacing the air fuel ratio sensor.

Click here

*a

Torque Wrench Fulcrum Length

(a) Using SST, install the air fuel ratio sensor to the exhaust manifold.

SST: 09224-00011

Torque:

Specified tightening torque

44 N*m (449 kgf*cm, 32 ft.*lbf)

NOTICE:

Replace with a new part if it is dropped or if it receives a strong impact.

HINT:

  • Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.

    Click here

  • When using SST (fulcrum length of 30 mm (1.18 in.)) + torque wrench (fulcrum length of 180 mm (7.09 in.)): 37.7 N*m (384 kgf*cm, 28 ft.*lbf)

(b) Connect the air fuel ratio sensor connector.

(c) Attach the radiator hose clamp.

2. INSTALL NO. 1 EXHAUST MANIFOLD HEAT INSULATOR

Click here

3. CONNECT INVERTER RESERVE TANK ASSEMBLY

Click here

4. CONNECT WIRE HARNESS

Click here

5. INSPECT FOR EXHAUST GAS LEAK

Click here

READ NEXT:

 Camshaft Oil Control Valve

 Components

COMPONENTS ILLUSTRATION *1 CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY *2 NO. 1 ENGINE COVER SUB-ASSEMBLY *3 O-RING - - N*m (kgf*cm, ft.*lbf): Specified torque ● Non-re

 On-vehicle Inspection

ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY (a) Connect the Techstream to the DLC3. (b) Turn the Techstream on. (c) Put the engine in inspection mode (mainten

SEE MORE:

 Operation Check

OPERATION CHECK OPERATION DESCRIPTION NOTICE: Make sure that the smart access system with push-button start (for Start Function) has not been canceled before performing this inspection. Click here (a) Push-button start function: (1) When the electrical key transmitter sub-assembly is in a detectio

 Lost Communication with Gateway Module (Main Body ECU) (U1002)

DESCRIPTION The main body ECU (multiplex network body ECU) will store this DTC when no signals can be received from the ECUs that have been memorized as those that are connected to sub bus 1. When the main body ECU (multiplex network body ECU) receives a response signal from the ECUs connected

© 2016-2026 Copyright www.lexunx.com