Lexus NX: Automatic Light Control Sensor
READ NEXT:
Components
COMPONENTS ILLUSTRATION *1 AUTOMATIC LIGHT CONTROL SENSOR *2 NO. 1 SPEAKER OPENING COVER ASSEMBLY
Removal
REMOVAL PROCEDURE 1. REMOVE NO. 1 SPEAKER OPENING COVER ASSEMBLY Click here 2. REMOVE AUTOMATIC LIGHT CONTROL SENSOR (a) Detach the 2 claws and remove the automatic light control sensor.
Inspection
INSPECTION PROCEDURE 1. INSPECT AUTOMATIC LIGHT CONTROL SENSOR (a) Disconnect the automatic light control sensor connector. *a Front view of wire harness connector (to Automatic Ligh
SEE MORE:
Lubrication System
On-vehicle InspectionON-VEHICLE INSPECTION PROCEDURE 1. INSPECT ENGINE OIL LEVEL (a) Put the engine in inspection mode (maintenance mode). Click here (b) Warm up and stop the engine 5 minutes later, insert the engine oil level dipstick and check that the engine oil level is between the L and F ma
Installation
INSTALLATION PROCEDURE 1. INSTALL THEFT WARNING SIREN ASSEMBLY NOTICE: Do not reuse parts if dropped or subjected to any strong impact. (a) Connect the connector. (b) Temporarily install the theft warning siren assembly by attaching the 2 guides of the theft warning siren assembly
© 2016-2026 Copyright www.lexunx.com
